Wonderful job. I'm so grateful 🙏. I'm happy no much damage yet I put this unit over 50k miles while blowing out oil really bad
@JoesBusBarn3 жыл бұрын
That my friend is going to be a thing of the past. You are going to be driving an entirely different truck (running engine). Truck is going to be back on the road. No more clouds of smoke no more excessive oil consumption
@sts.5563 жыл бұрын
just repaired one that was dumping all the oil into the fuel tank in like five min,
@stevemazzarella72123 жыл бұрын
I’m enjoying this!! Are you going to double dog bone the lifters? The front engine support mount is a pain, we made an engine support that sits on the axle.. it supports the block while infram is being done.. cant wait to see the rest !!!
@kevinenriquez822 Жыл бұрын
Could u get away with out resurfacing the head if the head gasket is barely leaking I have maybe one drop of milky residue on my dip stick and doing this job in my driveway and need to back to work ASAP
@JoesBusBarn Жыл бұрын
Yes. You could. It’s not recommended. Use a straight edge and feeler gauges after you clean the head/block mating surface. To get and a better idea if the head is warped.
@tildenyoung20883 жыл бұрын
HEY JOE…Not a bus but I love ALL international/IC now🤣…Could you please talk to me man…Haven’t heard from you in three months…Also hope your friend is feeling better…Prayers to him…Also could you check the message I sent you…❤️
@JoesBusBarn3 жыл бұрын
Hey there Tilden. It has been a while. I’ll check my email for the message sent (your message) and make sure I respond Thank you for watching and continuing to follow and be part of the Jjoes bus barn family my friend.
@tildenyoung20883 жыл бұрын
@@JoesBusBarn It was a IMessage, so it should be in your messages app…And NO PROBLEM…I Will always be apart of this family…!!!!
@harleyhoracio13 жыл бұрын
Do you send the injectors out to get pop checked and the spray pattern checked?
@JoesBusBarn3 жыл бұрын
We send them in to a local shop to get check’d/repaired.
@harleyhoracio13 жыл бұрын
Do you replace the head studs or just reuse the old ones?
@JoesBusBarn3 жыл бұрын
I always replace head bolts. They tend to stretch out a bit.
@vatolocooperations61113 жыл бұрын
Is it true what they say if you remove fuel lines to put a plastic cap on them or is just bs they put in books?
@JoesBusBarn3 жыл бұрын
It’s to keep the from draining out. To make it easier to bleed out air from the fuel system.
@JoesBusBarn3 жыл бұрын
And yes. Books are good sources for info but visual (video) has always been my favorite too.