If your dyson doesnt stay in upright position- try these tips
Пікірлер: 19
@daynahall9639 Жыл бұрын
I was completely freaking out my dyson was broken but this fixed it in 10 seconds. I love you
@andreah6175 Жыл бұрын
Superb! As a visual learner as soon as you pointed out the area around 30/32 seconds I got the problem resolved just from just seeing that. Only removed that side piece & nothing else, basically the rest was irrelevant for how simple it was : ) Thanks!
@gretchenwilliams20912 жыл бұрын
Thank you so much! We have been pulling our hair out trying to figure out what was going on. YEAH!!!!!!!
@yorkknight2 жыл бұрын
You are so welcome!
@paula312410 ай бұрын
By taking that first bend out at 53", you'd actually fixed the problem. If you'd left it in the upright position you had it in at 1' 29" & replaced that first piece, it would have held it in the correct position & the Dyson would have stood upright perfectly. It was only the first piece you removed that prevented it. Someone had ovbiously removed it & refitted it incorrectly when the Dyson was in the angled position. I had exactly the same problem 10 minutes ago, & fixed it in 10 seconds.
@vanessacourtney2217 Жыл бұрын
Thank you🌞
@lafinfindley8803 Жыл бұрын
What did you use to "polish" it?
@yorkknight Жыл бұрын
any household furniture polish will do
@jayambermsp80002 жыл бұрын
Do you take the valve carriage and forward lock out to be polished?
@yorkknight2 жыл бұрын
No-I just cleaned it in situ and polished as well as I could the same way. If you work it up n down the polish spreads around ok. Yorky
@jayambermsp80002 жыл бұрын
@@yorkknight I'm going to strip it down and wash it then I'll add the polisher to it and see how it goes.
@jayambermsp80002 жыл бұрын
Hi, is there any way to get scuffs on of Dyson chassis? Many thanks.
@yorkknight2 жыл бұрын
If they are paint from skirting boards- try thinners or turps on a rag. Some of those "magic erasers" remove some marks too. Yorky
@jayambermsp80002 жыл бұрын
@@yorkknight It's not paint marks it more of a light scuff on the top of the chassis.
@jayambermsp80002 жыл бұрын
What causes it to not recline?
@yorkknight2 жыл бұрын
The spring/holding mech is siezed?
@Fightcf2girls Жыл бұрын
What about the animal 2?
@yorkknight Жыл бұрын
The animal version of each model listed is exactly the same to do the clutch cover
@yorkknight Жыл бұрын
Sorry - wrong reply, The stand mechanism works the same on animal upright - excluding the ball type