E-Moto Chain Tension How To // E-Ride Pro, Surron, Talaria

Рет қаралды 1,487

2 ай бұрын

Thanks for watching!
Please consider subscribing!
CHECK OUT OUR WEBSITE FOR ANY UPGRADES YOU ARE LOOKING FOR ⬇️⬇️
tbelectricmoto.com/
Best 19in Upgraded Tires: tbelectricmoto.com/products/t...
Talaria Pedal Kit, Talaria Sting R MX4 vs E-Ride Pro SS, Best Sur Ron Controller, Talaria X3 Street Legal, Talaria X3 Controller Upgrade, Best Electric Dirt Bike, Talaria Direct Mount Stem, Surron Ultra Bee Upgrades, Talaria Sting R Unboxing, Talaria Sting R Battery Upgrade, Most Powerful Electric Bike, How to Change Talaria Brake Pads, Talaria, Surron, EBike, Utah, Trending, Talariasting, Dirtbike, Emoto, ForYou, TalariaXXX, Talariax3, Talariamx4, Talariamx3, Surronx, ForYouPage, TalariaStingR, Talariar, StingR, FYP, Shorts, ForYou, Utah, Moab, ElectricMotorcycle, SurronX, Luna Cycle, Review, Ebike Review, Sting R, Super Moto, Faster Than Surron, Best Electric Bike, Under $3000, XXX Unboxing, XXX Review, Sting R Review, Talaria Review, Surron Review.

Пікірлер: 22

@surronsd Ай бұрын

10-15mm is chain slack is all that’s needed. Just tightening the axle nut will give you inconsistent chain tension. Put a towel in the chain and roll wheel forward. Will set axle blocks against tension bolts. Tighten axle nut and then roll wheel back and remove towel. Chain tension will always be the same

@B0G3Y Ай бұрын

Please make a video going over proper front and rear suspension settings. I have an E Ride Pro SS 2.0. I am new to the whole scene and feel like my suspension is probably not correct and I cant find any info on how to set it properly. I also want to know in case I have a bad rear shock like you guys had on your 2.0.

@TBElectric Ай бұрын

Will do

@TechLineHD Ай бұрын

Thank you for providing valuable content. Gonna check the tension on my Talarias using your tutorial

@TBElectric Ай бұрын

Thanks!

@RAZ13L Ай бұрын

I would like to see the brake pads replaced

@TBElectric Ай бұрын

Video coming soon

@keed333 Ай бұрын

just got my sting friday, haven’t cut the wire, chain seemed tight when I got it, rode 8-10 miles, noticed it had worn in and would move about an inch and a half up between the sprocket and gearbox. got it tightened up, only thing is I was unsure of wether or not it’s too tight, I saw people saying 10-15mm of play in the middle, seems like it’s close to that but i’m also guessing it may wear in a little more?

@racingfortheson Ай бұрын

Because of the flex in the swingarm I have to run mine a bit loose. When hitting big jumps and scrubbing it will bent the sprocket as you land.

@TBElectric Ай бұрын

Good to know

@racingfortheson Ай бұрын

@@TBElectric yeah, I bent 3 sprockets before I switched to the titanium axle and started running my chain with a bit of play

@Ubergamer256 Ай бұрын

On a Talaria?

@Alex-oy6wb Ай бұрын

Still don’t understand how you measure the “play” on the chain. Ppl in comments say 10-15mm but how the heck do you measure that?

@inputlyric162 Ай бұрын

The brake side for me doesn’t move no matter how much I turn it, i assume it’s broken?

@TBElectric Ай бұрын

Ya that’s not good

@inputlyric162 Ай бұрын

@@TBElectric what do u think I should do?

@vladimirp8470 Ай бұрын

Same here neither side will move at all

@inputlyric162 Ай бұрын

@@vladimirp8470 I emailed luna n created a ticket, if they get back to me I’ll relay the information to u if you’d like.

@inputlyric162 Ай бұрын

@@vladimirp8470 I’m not sure on how to fix it rn, but I’ve emailed Luna n created a ticket asking for advice. I’m gonna go on Reddit later today and see if anyone has had a similar problem.