Рет қаралды 495,403
3d printed part files:
www.thingivers...
please use the manufacturers torque specs, for the parts you are installing.
sry for the poor video quality, my gopro is slowly dying at the moment.
Parts list:
Frame:
-Bomber Electric bike Frame
Hub motor:
-qs273
-corrugated pipe d=17mm
-nylon cable sleeve d=19
-cable gland d=?
Tires:
-Vee rubber vrm 140 70/100-19
Wheels:
-19“ motorcyle rims (alieexpress)
Brakes:
-Magura MT32 (rear)
-2xMagura MT5 brake caliper + magura t-piece + magura brake line+ magura big brake pump (front)
-3x 203mm brake rotor
Controller:
Sabvoton 72150 (without display option)
Battery:
-20S11P Samsung INR18650-30Q (33Ah)
Bms Li-ion 20S
80A continuous, 160A peak
-72V 8A charger
(note that there are even better cells out there, wich can handle up to 30a, mine can only handle 15a per cell (Sony 18650 VTC6 for example))
Seat:
was used from my old bike:
Suspension:
-dnm usd8
-fox vanilla r / dnm burner-rcp2s
Bearings (normally included with the frame):
-shimano bb-un26/68 127,5mm
-ritchey com zero 44mm
Stuff around the handlebars:
-Set of 1.1/8“ spacers
-bbb ahead clamp 1.1/8“
-xlc pro ride d=31,8mm, 50mm
-sixpack kamikaze 780mm
-3 speed switch 22mm
-on/off switch 22mm
Domino e throttle
pedals, chain etc:
-leili enduro kickstand
-sport direct chain 1/2 x 1/8
-sumgott mtb pedals
-48T 170mm single speed
Electric stuff inside the frame:
-battery switch 200A
-anl fuse 150A
-terminal block
-usb switch
-xt90s connectors (10 pairs used)
-jst sm connectors
-cable shoes
-electrical tape
-shrink tube
-cables with different sized cross sections for extending existing cables
-cable clips