End Of Day9 27 2021 LLY Fuel Injector Control Module?

No video

End Of Day9 27 2021 LLY Fuel Injector Control Module?

Рет қаралды 7,244

Hands On Auto Training

Күн бұрын

Underground again for the Chevy Truck!

Пікірлер: 16

@ekydegnuoy1 3 күн бұрын

I'm looking into why my 25amp EDU fuse keeps blowing, like a direct short. Even with FICM Unpluged. Where did you get wireing diagram for the 2005 duramax LLY. Thanks for your help

@BrianMann216 2 күн бұрын

All data

@joshcarter3743 Жыл бұрын

Hi sir,I’ve actually just took apart the same ficm,i was wondering how did u get the circuit board up to where u can desolder and solder in new capacitor?mine is glued in the box

@carolinacespedes-uribe4545 2 жыл бұрын

Hey! Quick question! Do you know where can I find the ohms measurement to see if the sensor is good for a 2016 Nissan Rogue driver’s satellite airbag sensor? Thank you!

@BrianMann216 2 жыл бұрын

I am not sure

@Franklinveterinarycenter1of4 Жыл бұрын

what did you find inside the module....

@ronfrick2360 2 жыл бұрын

Hello. I have an issue finding a Fuel injector module for my 2005 silverado duramax diesel. Any suggestions?

@BrianMann216 2 жыл бұрын

Lol no I don't have enough problems with the one I am working on. What codes do you have?

@8power0 2 жыл бұрын

GOOD ONE !!!!!!!!

@jr.granados4670 2 жыл бұрын

I have the same problem. I have 20 hours into this. Did you figure it out?

@BrianMann216 2 жыл бұрын

I have not located a fuel. Injector control module. Job on hold

@jr.granados4670 2 жыл бұрын

@@BrianMann216 i did ome from advance and had same codes. Im gna try to find a used one. Oem.

@joshcarter3743 Жыл бұрын

04 duramax

@cliff499 2 жыл бұрын

Shorted injector ?

@BrianMann216 2 жыл бұрын

That is a great Question / Idea! I have not thought about that. Maybe I can cut the 2 power wires to the injectors and see if communication comes back! It is such a pain, close to 1 hour drive to get to the mine from my home, then its usually a 30 minute to 2 hours adventure to get to the vehicle. I did pop the case off the module looks good on the side that I can see.