Preforming a compression test on a suspected bad engine.
Пікірлер: 19
@MustangGuru2 ай бұрын
2011-2014 have sunken intake valve issue. Mainly cylinder 4 and 8.
@MustangGuru2 ай бұрын
Sounds like someone didn’t time this engine per GEN1 proceadures and bent the valves
@DrPoopee792 жыл бұрын
Might have overheated the heads. several o rings go bad on the coolant lines regularly. Mine seems low on coolant every time I check. I have replaced the coolant lines to the radiator and expansion tank. Still leaking somewhere. Now it started missing and has low compression on #8 like many other 2011 5.0s
@jasonmundell Жыл бұрын
I have a truck same symptoms low compression on all cylinders. Checked timing still on, pulled cylinder head. Still off, sending it to Machine shop but looks fine. Wondering what solution was, this truck has an extended warranty but I need initial cause to show warranty company?
@malcolmkennedy6522 жыл бұрын
What brand reman engine was it? Ford? Jasper? Powertrain Products?
@joshsautoandcustoms98402 жыл бұрын
For legal reasons I cannot divulge at this time. I can confirm it was none of the ones you listed.
@MustangGuru2 ай бұрын
What did you find out?
@benjaminstonecipher192 жыл бұрын
what are the numbers supposed to be on this engine?
@joshsautoandcustoms98402 жыл бұрын
According the the engine builder it should be in the 130 psi range.
@amrikjaswal768 ай бұрын
Hi when you turn it over....are you putting foot all the way down on gas pedal or just turning key?
@joshsautoandcustoms98408 ай бұрын
Just turning the key.
@mikefoster41055 ай бұрын
U have to have the throttle fully open or you’ll always get low numbers
@joshsautoandcustoms98405 ай бұрын
@mikefoster4105 that is not an accurate statement. The compression test doesn't measure air volume. It measures the pressure being built by the piston compressing the air in the cylinder with the valves closed.
@mikefoster41055 ай бұрын
@@joshsautoandcustoms9840 just stating what the directions on the compression tester states I could be wrong
@wryanddry22663 ай бұрын
@@joshsautoandcustoms9840 If the throttle is closed, the pistons are pulling vacuum, and they aren't getting enough air to compress?
@Trytooooo3 ай бұрын
I don’t have a fuel pump relay fuse it’s empty and I drive the truck? Is it supposed to have one