Im running these on my work trailer for my side markers and reverse lights. Wired in a key fob controller so I’m now able to have an amber/white strobe as well as a flood option for loading at night. This light is super impressive.

Excellent

What about break pop with turn signal work together? I mean if will setup the break pop on 1st mode and turn signal on 2nd mode.

Does the T3 “steady on” mode keep them on indefinitely? On their site it says 3 seconds next to the mode, but not sure what that meant. Trying to decide between the T3 and Q3, but I need an indefinite steady on mode…

One thing I am trying to find out, that no one mentions is what is the higher priority between the modes? One video from Fenix says the higher number, so 3 would override everything? Or do they count 1 as the highest? I want to have it set for say steady Red on one mode, steady white on another and steady amber at 10% on a third. I want to use a flasher system, like a Pathfinder, and have in level 3 it flash the red, when white flashing is activated, it will then activate another output and alternate the red with the white. The modes will not conflict, or shouldn't as the outputs are alternating, so it will not have two active at the same time. However, if alley lighting is activated, the white will override everything, so this will need to be in a higher priority mode than everything. The third, thing I want to do is have the least priority is set amber to turn signal, basically will be a turn signal anytime lights are not on, but if they are activated, they will override any amber function. I want to have these for the mirror caps for a Tahoe. They will be the only Feniex lighting on the build, everything else will be Federal Signal. So I don't want them to just flash their own patterns as I will also have the under mirror lights from Federal as well.

I wish someone would show how to hook up all the wires I’m confused with how to wire the blue wire on the t3 lights to change the patterns on a set of 4 to 6 lights

Can you possibly help answer if these will work for my particular project? I would like to have 2 of these in the grill of my truck as follows: -One mode would be full brightness, steady amber. -A 2nd mode would be full brightness, steady white. -A third mode would be strobe: alternating between amber /white and alternating sides. (One side flashes while the other is off) This would basically be for white DRL lights during daytime, Amber running lights for night time, then strobes when Hazards are on, My alarm is triggered, or needing to get attention in the desert. Hope this made sense - tried to be a clear and simple as I could be 😊 Thanks a bunch man!

Which wire is the sync wire once you have the colors/patterns/modes set? I can't find the manual online or using their QR code. Thanks

Is there a way to adjust brightness because mine don’t seem to be as bright as other videos?

Is there no way to have individual control of each color? For my build I need control of all 4 but it seems like you can’t do that

You said reverse turns it into a scene light but how without cycling through all the modes, that wasn't explained or is anywhere in their manual. I want yellow flashing on both lights all the time and then another switch to turn it to clear scene light without having to scroll through modes

Clean ur nails if ur gonna do hand work...or get some gloves! 😅

Are the other mode wires 12v +? So when working with other modes I wouldn’t need to tap into the main red?