Thanks for your video, it is very helpful. The motor pump was blocking the machine from normal start. But in my case, I opened the pump and found a piece of dust blocking the fan from spining. I tested the motor with a 24v power supply and worked like a sharme. My CO2 Laser machine is working fine now without replacing anything. Thanks again my friend.

Mine burnt up after a month. Replaced it with a condensate pump from a furnace lol it worked great!

If you have a cnc machine that has a pump integrated can you by pass the small pump in the chiller as its not needed and still set the temp on the control.

What would cause a cw5200 to keep tripping the circuit breaker in the premises? It Powers on for 20 seconds or so then trips the circuit breaker in the premises

The all-important question here is where to source a pump. Mine appears to be weak, it's not trupping the flow sensor on the laser, and although some water is circulationg, the green light is not coming on.

thanks

Ours the display is on but I don’t think the pump is running but not sure how to confirm. I took the outflow pipe off and nothing pumps out so I don’t think the pump is working

Link where I can buy the water pump please