I have both the 87v and T6-1000. The T6-1000 is always my go to for most troubleshooting issues in the industrial world.

I am new to this channel and is really good because of the plc programming explained clearly specially for new people to plc staff like me 👍

I've used the T6-1000 working with 480v 3 phase motors. I like that the OHM range is high enough that when reading a motor you can see if the winding insulation is starting to break down. I also like the red danger light because if you forget and test your wires on OHM's or AMP's and read 0 it still alerts you that possibly dangerous voltage is present. Would definitely recommend for a tech working on anything from 3 phase 480- 24v DC. The other thing to note is that it holds one of your leads with the end of the meter so if you are measuring you're not trying to hold 3 things at once or trying to set a meter in a live MCC bucket while you test.

That AC/DC combo is pretty cool!

T6-1000 greatest meter/tester ever made. I want an 87v REALLY bad though

T6-1000 has been my go to meter aka “the workhorse” for a few years now. I love it my only complaint is I wish the leads were maybe 7”-10” longer. I live this thing regardless.

T6 1000 recommended for apprentices in Australia, many sites require the CAT IV 600v too.

personally use a 1587fc for most of my jobs cause it does most of what i want in my overall pocket

Pretty sure I read in the manual field sense doesn’t work on the outputs of vfds fyi

For basic first line testing it is a decent enough meter; I did find the Field Sense a bit of a gimmick though so I tend not to use it.

If the meter just shows the correct value automatically then learning fundamentals are missed, IMHO