I just did this but i used a microusb breakout board. i didn't use any glue or make any holes. i ziptied the female microusb board to the handle. Then I soldered wires to the board and soldered male headers to the other end, which plugged into the D+,D- and GND pins on the flysky barrel connector. This way I didn't have to make any holes or use glue, and it would make it easier to sell online if I plan to upgrade
@zhaba66946 ай бұрын
Здравствуйте какая распиновка была у оригинального кабеля s video - usb a?
@dronescheck39917 ай бұрын
What is the ground on the mo ther board connecter to
@rsmgaming4384 Жыл бұрын
Any driver I have to install because I am getting an error unrecognised usb please help 😢
@starr19786 ай бұрын
No driver needed. Prefer to check the wires again, they are connected in the good order. Take attention when the USB connector turns on the video, belong to trapezoid connector shape which wire is where.
@rsmgaming4384 Жыл бұрын
Can you please tell the connection for flysky Fs-i6
@starr19786 ай бұрын
Only the FS-I6X includes the chip what can connect via USB. For FS-I6 needs external module.
@chrismagallanes8858 Жыл бұрын
Is it be a USB type c
@starr19786 ай бұрын
If you mean that, you want use with mobile phone, then it's possible. I did, but need OTG which includes the power control chip. I used with Samsung Note 8 with own Samsung OTG.
If you mean that, you want use with mobile phone, then it's possible. I did, but need OTG which includes the power control chip. I used with Samsung Note 8 with own Samsung OTG.
@1947Scooter2 жыл бұрын
The worst transmitter I ve ever used
@starr19782 жыл бұрын
just cheap
@yaimem5 ай бұрын
why? i have both fs-i6 and fs-i6x and they are really good