Thanks for not having your own software or library of content to sell on every single one of your videos. I subbed.

Because of your recommendations of the FoMako products, my church purchased the KN30A and KN20A PTZ cameras and the KC-608 controller. This past week-end I was successfully able to convert our existing SlingStudio live stream setup over to the Blackmagic ATEM Mini Pro Extreme system. I am thrilled with our new FoMako camera hardware as the results it produces are remarkable. The fact that the we were able to hook up all the FoMako equipment using just an ethernet connection was fantastic and greatly reduced our cabling requirements. Your channel has been invaluable in your recommendations and tips. It has literally saved our church a lot of money. Thank you sharing your expertise.

Awesome video! Just a quick question for you! I'm working on setting up a church livestream, and I'm wondering if the FoMako PTZ controller/camera supports gradual movement, or is it stepped or all or nothing. On some controllers, if I shift the controller joystick just slightly, it'll move the camera slowly, and it responds to more joystick input smoothly. On other controllers, there's one speed no matter how much you adjust the joystick (the camera is either moving or isn't), or the speeds are stepped like gears on a car so that the adjustments aren't smooth. I was wondering if it's possible to get smooth/fine control out of this for live tracking shots.

Hi was was wondering how you would change the mode to onvif mode as ours is stuck on sony

How do i connect my controller to the pc or osetub

Can you connect a controller to a camera with absolutely no internet?

Do you know what is the network speed of this controller? I found that most controllers are only 100mbs not 1000mbs and this will cause a lot of lag when used with PTZ NDI cameras, they are unusable with NDI because this detail. Is there any controller you know works in a NDI only camera environment?

We are actually looking at purchasing this very FoMaKo switcher. You said it doesn't do NDI what did you mean by that? Also, I'm looking for the best solution for my multi-PTZ camera operator to view the 4 cameras that person will be operating. What is the best solution, OBS? Is there something better?

Good stuff! Thought about doing the fomako with the viewing screen? @foundery

Hi. I am subscriber of your channel. I had a question about the ptz camera protocol for Newtek ptz 2. Does Newtek PTZ2 camera will operate using both of these controllers that you have used in this video? Thanks 😊

Since it doesn't have the preview screen, can you set up an external monitor, separate from the video feed to the ATEM switcher?

You say that it doesn’t do NDI, but the link you give does show NDI capability.

It does not find my prisual PTZ camera IP so i cannot use it to control my camera. it only find my fomako camera and inly works with fomako. how did you make it work with your non-Fomako PTZ camera

I have the KN30A with KC-608 all from FoMaKo. I having some real trouble connecting the system to the computer. Any advice to get the picture and connection onto the computer screen. I have all IP addresses correct. I'm trying to set up for a church. Thank You in advance.

It's Fomako, not Fokamo.