Hey there, I didn't test resistance. Found a bad 5v ref circuit which was the problem.

Gottcha. Would you happen to know the resistance range? Appreciate your help.

@@giff1011 sorry I don't. But if your 5vref, ground and signal circuits are good, then you have a bad sensor.

No worries. I actually have a 2009 F-150 in which the abs module needed repair. Well that repair didn’t fix the problem and come to find out my pressure transducer also failed. So I rolled the dice on a 2010 unit the because I wasn’t about to spend 5-6x more for a 09 unit. Both are 4x2 and HCU pump assembly are the same part number and bolted right in. What I didn’t know and found out last night when installed the 2010 unit is they have a brake booster vacuum sensor. The 2009 didn’t have it. So where I am now is trying to figure out the nominal resistance value of that sensor at 5v so I can modify the “new” unit into thinking I have a good sensor. I don’t have computer capable of modifying the ABS controller module otherwise I just do that. Thx again for helping and if you happen to find that number please let me know I appreciate it. Take care

@@giff1011 ah ok, can you just grab one from a junk yard truck and wire it in?