Love the videos where it shows everything that my cat can figure out, but how to remove the axle from transmission, because they all are stuck in there, nothing.

That’s brilliant mate,simple and straight to the point

Well presented. Makes what I thought would be hard, much easier.

My son hit a curb and bent the tire out. Lower complete arm ball joint end is broken and the shaft pulled apart at the u-joint in the boot. After watching your video, I don’t feel as overwhelmed. Brilliant Video!

Nice one, you made that task look pretty easy to do. I’ve got to replace the inner cv boot on that same part for a 2009 hatchback version. Not sure whether to replace just the boot or the whole shaft. Thanks for the great video.

thank you

Just found this video because I think I need to change the driveshaft unless you can get some of those bolt together boots like you can for an old Volkswagen?? Great video though mate.👍🏽👍🏽

Thanks a lot this is the very same as my mondeo MK4

I remember when first learning on cars i didn't have a complete spanner set and couldn't remove lower ball joint (wasn't a Focus, maybe an old Fiat or Vauxhall). In the end i unbolted the wishbone from the frame and did it that way instead.

Hey mate, awesome video! The old Focuses can be great little cars (even though there not little 😅), case & point, my parents still have their 2010 2L TDCI 6-speed manual hatchback that they bought new, but it is still running all the original parts! Only general, routine maintenance it's whole life, oh, and it's done over 265000kms, so yeah, great car

Great video 👍 - rookie question, what if you were only wanting to replace the CV joint itself, and not the whole drive shaft? I've got a joint replacement coming up - is it drastically different? Cheers!

Hey mate is it possible to install it wrong I left gsp shafts at shop and 3 days later all kinds of noise started, what could they done wrong??

super thanks

Any chance you could run through the oil top up? I can’t undo the 6mm hex I think is the fill level on the 5sp manual box..

Gear box ok losing that fluid? I dont know where to top it up😂

i had my rh shaft give me vibrations and have a replacement, I'm much more confident in doing it now. Just a question, My left shaft is nicely inline when steering is straight but the right seems have the wheel more in front of the shaft, like the engine is sitting back. is that normal for these? I have done all the engine mounts not too long ago.

Is this the same on a 2009 Ford C-Max with Automatic transmission?

I've managed to get the lower ball joint nut loose but its just spinning now? Any idea on how to get it off😅

Hi can u tell me how much gearbox oil goes into the 1.8tdci ford focus

Hello, mate I have a ford focus mk2 1.8 tdci and I feel a wobble under 'mild heavy' acceleration especially in second gear. The wobble is felt through the gas pedal and it feels like it comes from the right side of the car, I checked control arms bushings/ replaced the right driveshaft but to no avail.. what do you think it could be? some said it could be the driveshaft bearing, where is that located nd can it result in a wobble? the wobble feels like imbalanced tires but I balanced them two times already.. any help would be appreciated, the engine pulls strong but that wobble kinda ruins the driving experience..

3:39 Hi, does transmission side need new oil sealing? Or is it good to go with old one?

Sorry. Could you state the tightening torque values ​​of the various components? I forgot you don't speak Italian

I can’t get that last inch to go back in on the gearbox long drive shaft side any advice ?

if i do not have wd40 can i use crc?

what is axle oem part number for ford focus mk2.5 or 2010 model?

Potresti dichiarare i valori di coppia di serraggio dei vari componenti ?

First