Gman I thought the flux capacitor had back fired 💥 but hey your reasoning is just as possible 🐜 🐜 🐜🐜🐜🐜🐜

I agree!! Ants are real Bastards

Because it has coronavirus

That just made my day man lmao

That's why he has the big knife, to fight off any critters in the old rusty junk!

In which part of the world its already weekend?? Its thursday evening over here, lol. Another full day of work to go...

Reminds me of Homer sometimes. Mustie is the best!

It should have been a complete tear down and then start over.

I much prefer it to the so-called 'music' that so many think they have to add to their videos. The background noise in Mustie's shop is just part of the real world.

That's a good one! 👍👌👏

Or JAMES ARNESS FROM. THEM!!!!!!!!

Dear@@gertraba4484 That's funny. I just finished watching 2 movies with actor Arness (Gunsmoke and Hondo). What a coincidence! Best regards luck and health.

"The ant colony is startled into a frenzy.. this is the first daylight they have seen in over 9months, the queen retreats to the starter housing and the soldier ants form a blockade around her...suddenly a vaccuum comes soaring in from over the hill"

@bigpigslapper Oink lmao great comment!!!

Pretty sure he's half Canadian

haha he sure did in part 2

Never underestimate Mustie's determination and skill.

Yes, I think he's down to the Jurassic layer with the stuff in behind that transmission cover!

As far as I can think, he might be northern MA to NH line. Just from the surroundings and the places he has gone to get stuff. People in New England tend to throw away a lot of good stuff. I'm into computers and I go to the dump and have found everything from CPU's worth saving to memory to even fully built computers. I've even found a Mac Pro (the old tower type, Intel Xeon) with only missing HDD and a bad DVD Drive.

Have you watched the video yet?

I'm blown away by the freebies he finds. Ppl there must have plenty of money. I never see stuff like that out here on the west coast.

Yep. Southern New Hampshire on the Mass border.

@@billydarley6925 3 words.. TOO much money.

Nah, I’d take a shirt with crusty the vw on it

Yeah, that would be great. Or a mug with a Ha! laughing Mustie1 picture or Mustie1 face cartoon!? Best regards luck and health.

+1 to all of that! Mugs, Tees... "Will it run?"

@QuestionMan Nope. It WILL inevitably run. Lol.

Safety third or there’s a joke in there somewhere. Or no girls no politics just rusty junk.

Jack Jacke this was my first thought as well.

@@fuzzyjax Nah, spinning the engine over backwards.

@@danmackintosh6325 He is turning the Bendix clockwise to engage the starter gear (its on left hand side), causing a counterclockwise rotation of the engine. When he is spinning the engine by using the rotor nut (right hand side), he is spinning the drill clockwise. That would cause the CVT clutch, (left side) to spin counterclockwise, its spinning the countershaft, that has a sprocket on the right hand side, that spins clockwise. Facing left side of the engine, it spins counterclockwise, facing right hand side (thats the side he is spinning the drill from in a clockwise rotation) the engine spins clockwise. At 36:40 you can see him turning the bendix clockwise, engaging the starter gear, causing it to turn counterclockwise. If you were able to see the rotor on the right hand side of the engine it would be spinning clockwise, the same direction he spins the drill.

@@twiz8789 That was my observation too. I think all the shaking around while he was spinning it with the drill caused the bendix gear to re-engage into the crankshaft gear, causing the sudden stop. I didn't see enough water to cause hydro lock, but maybe? It's a two stroke, so maybe some was forced up the intake ports from the crankcase, into the cylinder? I don't know though, because the base gasket was shot, so no compression from the crankcase, may not be able to force water into the cylinder. He's lucky he didn't break his thumb, that was a pretty violent stop.

@@trevorjameson3213 if the engine drives the bendix it throws it in. That's kind of the point of it.

yes thats were the dam mice always put the nuts,lol

...but not today! Owww! 43:51 😂

I'm not so sure on this one. The top end was full of rust and water. It's not worth it for an old 80cc quad.

me too!!! I didnt forget either

Same

I like how it says free like free rocks in your shoe or free ants in your pants.

i doubt it was spinning fast enough to engage the clutch

i dont think if it engaged it would snap like that to a stop, it could definetly slow it down quick but not like that

that's funny

Only on 1 side! The other side was nuts.

Lol just quit my job today to go work somewhere else less boring!

Maybe Mustie1 can hire you as an assistant. I think he may be in search of a dedicated drill guy...

@@erikj.2066 I'm not sure what a dedicated drill guy does, but I'm pretty sure I'd do it if it meant wrenching (or drilling) around in a garage all day with Mustie1.

@@bobcranberries5853 I'm self-employed - LOL. What do I tell my boss!?

BadDismount427 just look him in the mirror and tell him take this job and shove it!

NEVER watch his videos with something edible close by!!!!!

Well that'll teach you to eat a sandwich so close to what Mustie is working on.

I was mid-sandwich when he opened the box with the fan. Almost lost it.

The last person to see what Mustie sees was the assembly line workers.

Yep. The LT50 is the complete opposite of this thing. This looks like a pain to work on.

I thought so too but at the end of the video Darren has the back wheels lifted to delete that from happening. I say it caught the dead starter motor or is hydro-locked. Either way this unit is FUBAR.

No. not even fast enough to engage the cvt clutch

@@stevewaller6577 Mustie doesnt know what FUBAR is, he will have this thing running like a sewing machine in about 2 more videos ! LOL

@@warrenmichael918 idk i think this one is just an exploration video, its gonna need a starter, a carb kit, probably a piston judging by the end scene and some gaskets for the cylinder and bottom end.. and that doesnt even touch on tires brakes and the rest of the machine.. he can fix it but he certainly cant make a profit or even break even off of it

@@AndrewBrowner part 2 , purs like a kitten ! Its amazing what this guy can bring back to life..

true indeed, but the motor wasn't turning when he pryed it

why not? They all mechanics?

@@n2cable you see them but you will not get this stuff for free like it is there

@@chick99936 what do they do with them then?

@@n2cable Mainly it's a matter of finances, we have to pay the local councils £40+ per item for them to come and collect "large" items (fridges, beds, mattresses etc) or we can take then to a recycling centre ourselves, once there the recycling companies licences forbids them re-selling items, they have to be scrapped under strict conditions.

@@Boerkie1990 well its not that bad yet but it will be like that here soon

I noticed that too. Was going to go back and check but no need now.

Me too👍

I think that starter is beyond tapping, more like hit it with the BFH

@@Adamsadventures83 lol, maybe,,, :-)