FREE WATER, I Installed a Pitcher Pump on an existing well head.

  Рет қаралды 27,484

Sterling Dewey

Sterling Dewey

6 жыл бұрын

See Part 1 at • Installing A Pitcher P...
We had an unused water well in our yard. Now we can use it for watering around the yard.
We do not drink this water. Always have well water tested for safety.
I bought this hand pump, pitcher pump, at Harbor Freight.

Пікірлер: 25
@dalehammond1704
@dalehammond1704 Күн бұрын
Good idea. We found an antique Davey hand pump at a garage sale and my wife wants it in her garden. Thanks
@carolmurray5794
@carolmurray5794 2 жыл бұрын
I like that box.
@340wbymag
@340wbymag 3 жыл бұрын
We purchased a few acres recently and found a capped water well there. I plan to drill a hole in the cap and install a hand pump just like you did. I hope my plan works out!
@sterlingdewey
@sterlingdewey 3 жыл бұрын
Sound good, hope it works out. Be careful of how you use a wells water. you can have it tested for water quality. Thanks for your comment.
@xungngo
@xungngo 2 жыл бұрын
Looks nice, but remember water and wood don't mix well in time. Maybe cover it up with a water sealant?
@sterlingdewey
@sterlingdewey 2 жыл бұрын
Thanks!
@myway3343
@myway3343 3 жыл бұрын
That looks nice. Suggest putting a patio block on the ground where the water hits. Great job>>>
@sterlingdewey
@sterlingdewey 3 жыл бұрын
Thanks, I did put patio blocks down and I like the look.
@CreatingASimplerLifeOffGrid
@CreatingASimplerLifeOffGrid 6 жыл бұрын
Looks really nice!
@sterlingdewey
@sterlingdewey 6 жыл бұрын
Thanks, and thanks for viewing..
@williamgermann6551
@williamgermann6551 5 жыл бұрын
@@sterlingdewey I am working on making a fountain. Just an idea to further beautiy ypur good looking pitcher pump.Get a full size oak barrel, new or used leaks or not.run the pipe you hid through the barrel and mount the pitcher pump on top.The barrel can be costly or cheap.Good luck!!!!!!!! call or ask Billie Gee
@sterlingdewey
@sterlingdewey 5 жыл бұрын
@@williamgermann6551 Thanks for the idea!
@dr3754
@dr3754 4 жыл бұрын
looks great. i was wondering if you were thinking about doing stone around it instead of wood? might be sturdier and more long lasting? but anyway thats great to have in the middle of the yard and i bet will inspire you to do more plantings.
@sterlingdewey
@sterlingdewey 4 жыл бұрын
Nice idea! Thanks
@eddiedeleon2425
@eddiedeleon2425 7 ай бұрын
galing Sir dito nakadisplay din sa factory along highway near R.P BULARAN PUMPS
@blue_artifact7094
@blue_artifact7094 5 жыл бұрын
Did you say five quarter boards, 5/4? Like an inch and a quarter or 1.25?
@sterlingdewey
@sterlingdewey 5 жыл бұрын
Hi, 5/4 lumber is lumber that was rough cut to 1.25 inch. When it is finished planed, as you would get at a retail lumberyard, it will measure 1 inch. It is decking lumber for decks and steps. Thanks for viewing and commenting.
@aldenpines
@aldenpines 3 жыл бұрын
A week or so ago I had my well guy install a pitcher pump, with backflow preventer, teed off the pipe running to the well house where the pump is. I'm here in Florida and, unless that pump is covered somehow, all kinds of insects, frogs and oak tree debris is going to fall or crawl into the chamber where the piston rod moves up and down. The well guy didn't have too much of an opinion other than to note that, if covered, the cast iron would likely rust more. Any thoughts on whether it's necessary to cover the chamber and block the spout with a plastic bag between pumping it weekly to keep the seals wet?
@sterlingdewey
@sterlingdewey 3 жыл бұрын
I haven't had any problems with anything getting into mine. Hope yours goes well.
@aldenpines
@aldenpines 3 жыл бұрын
@@sterlingdewey Thanks, appreciate the reply!
@bacon10211
@bacon10211 2 жыл бұрын
Curious how much that set you back?
@aldenpines
@aldenpines 2 жыл бұрын
@@bacon10211 The pump was about $125 and they charged me $180 to install it. They teed off the pipe between the well head and my equipment shed. Took them an hour or so all told. I'd built a simple stand using a 6x6 post with 2x6 "stringers" which the pump is bolted to.
@dscdrkel5546
@dscdrkel5546 5 жыл бұрын
WHY DIDN'T YOU SHOW THE WELL HEAD BEFORE Covering IT?? rates a thumbs down
@Bag00ny
@Bag00ny 3 жыл бұрын
1 1/4" female threads on the inlet of the pump. I have the same pump and just got it reduced down to 3/4" to match the pipe going into the well. Very simple to install and works great.
Antique Hand Pump Well,  Start to Finish, at our Remote Off Grid Property
24:30
Can You Draw A PERFECTLY Dotted Line?
00:55
Stokes Twins
Рет қаралды 111 МЛН
아이스크림으로 체감되는 요즘 물가
00:16
진영민yeongmin
Рет қаралды 55 МЛН
This Simple Pump Will Blow Your Mind (Official Video)
13:34
Wranglerstar
Рет қаралды 385 М.
Old Hand Water Pump Restoration
13:10
Red Rust Restoration
Рет қаралды 18 М.
How To Drill A Shallow Well And Never Be Without Water
19:50
HAXMAN
Рет қаралды 6 МЛН
DIY DEEP WELL HAND PUMP INSTALLATION + RESULTS
23:39
Martin Johnson - Off Grid Living
Рет қаралды 531 М.
How a hand pump works
2:51
Engine On
Рет қаралды 2,8 МЛН
Can a Hydraulic Ram Pump Make a Perpetual Motion Loop?
8:02
The Action Lab
Рет қаралды 1,4 МЛН
Wirtz pumps are really clever
12:05
Steve Mould
Рет қаралды 13 МЛН
I dug a SHALLOW WELL and was told I can't use it...
20:29
Ambition Strikes
Рет қаралды 599 М.
DIY off grid well! Solar powered, gen power, hand pitcher pump and more! Part 2    #737
18:00
Pitcher Pump To Make Use Of Old Abandoned Well
27:46
post 10
Рет қаралды 74 М.