Furnace Maintenance Guide | Repair and Replace

Рет қаралды 89,866

Күн бұрын

In this episode of Repair and Replace, Vance shows how to clean and maintain a gas furnace.
Your furnace should be cleaned and inspected each year before its first turned on. This helps ensure that the furnace is running smoothly and gives a chance to identify any problems before heating is needed.
Learn more about furnace filters: • How to Replace a Furna...
Buy furnace filters online: www.amresupply.com/catalog/Air...
If your furnace isn't working, then watch our troubleshooting guide: • Furnace Troubleshootin...
Learn how a furnace works: • How a Furnace Works | ...
Need a part for your furnace? Order online: www.amresupply.com/catalog/650036
More furnace repairs: • Gas Furnaces | Repair ...
___________________________
00:00 Intro
00:40 What You'll Need
00:58 Step 1: Replace the Filter
02:19 Step 2: Clean and Inspect
03:17 Step 3: Clean the Blower
04:42 Step 4: Reconnect the Furnace
___________________________
AMRE Supply provides homeowners, service contractors, and property management with the parts and knowledge needed to get the best performance out of any property. Stocking the largest selection of appliance parts, heating, plumbing, lighting, and janitorial supplies, AMRE ships almost anywhere in Canada within 24 - 48 hours. Expert help is available online, over the phone or in person at one of the many locations across Canada.
Connect with AMRE Supply
Website - www.amresupply.com
Facebook - / amresupply
Twitter - / amresupply
Instagram - / amresupply

Пікірлер: 52

@AmreSupply 6 жыл бұрын

*Note* Be careful when pushing in the wire connectors into the circuit board. 4:26 Too much pressure can cause the board to flex and might crack the board. Its best to place your fingers behind when pushing in the connectors.

@shellygoins 3 жыл бұрын

Thank you for the great information and the slow and clear delivery.

@AmreSupply 3 жыл бұрын

You're welcome Shelly! We're glad that you found the video helpful!

@informationaccount2948 3 жыл бұрын

Vance is a very realistic robot!

@AmreSupply 3 жыл бұрын

Thanks for watching.

@DL101ca 2 жыл бұрын

They're called Androids.

@duanegirardin3262 3 жыл бұрын

Very well done !!!

@AmreSupply 3 жыл бұрын

Thank you Duane!

@happycamper2877 Жыл бұрын

Great info, especially on removing main blower motor, this is very helpful, thank you...

@AmreSupply Жыл бұрын

You're welcome, we're just glad that the video was helpful!

@khpa3483 3 жыл бұрын

That's what I wanted to see, thanks

@AmreSupply 3 жыл бұрын

You're welcome, we're glad you found the video helpful!

@yogeshsinghthakur1996 6 ай бұрын

Very well explained 🙏

@AmreSupply 6 ай бұрын

Thank you, we're just happy to help!

@tomference4618 Жыл бұрын

..nice clear instruction, not sure my furnace comes apart like this one did.

@AmreSupply Жыл бұрын

Thanks for watching. You are right that there is some variation in how furnaces are configured. If we do an update to this series we'll try to mention more of these variations.

@eddymaher4614 2 жыл бұрын

just great thanks

@AmreSupply 2 жыл бұрын

You're welcome!

@joaquinmariano6286 3 жыл бұрын

Very useful

@AmreSupply 3 жыл бұрын

Thank you Joaquin, we're glad that you liked the video!

@mauroaparicio1855 9 ай бұрын

great information

@AmreSupply 9 ай бұрын

Glad you liked it!

@beckyleung7233 2 жыл бұрын

very good

@AmreSupply 2 жыл бұрын

Thank you!

@diyhvacguy Жыл бұрын

Any maintenance that doesn't include cleaning the flame sensor is not a good maintenance.

@AmreSupply Жыл бұрын

Thanks for watching. This video didn't go into the specifics on the flame sensor or thermocouple as these are covered in other videos. We might however do an update to include those segments.

@otherZinc 2 жыл бұрын

Excellent video! #Question: My furnace is on and heats, however, the Blower Motor isn moving. -the Blower Motor isn't making a sound. -I turn the Blower, it moves freely and quietly. -I put the fan on On, nothing. What else can I look for? ULTRA V Tech 80 is my brand.

@AmreSupply 2 жыл бұрын

Thanks for watching, we're glad that you found it helpful. It could be a faulty furnace motor or a failed capacitor: kzfaq.info/get/bejne/armJa8-D0Z6shmQ.html

@wyllloukou5147 6 ай бұрын

Hello, I have yet a video about water heater filter cleaning.

@AmreSupply 6 ай бұрын

Thanks for watching. We have a water heater maintenance guide that shows how to clean the flame arrestor screen on the bottom of a standing pilot water heater: kzfaq.info/get/bejne/kLqFga96vbG6pWg.htmlsi=hweIyFjcllBAQwiT&t=158

@shakirahmedtth Жыл бұрын

When I open the front cover for vacuuming inside the firnace, there was something like filter attached to that front cover. That filter kind of thing was very dirty and broke. What do we call that one? It is round fiber something. Where to find it. Can we turn on furnace without that? Just closing the front cover?

@AmreSupply Жыл бұрын

Thanks for watching. Are you referring to a gasket that goes around the entire edge of the front cover? Or is the filter wider than an inch?

@shakirahmedtth Жыл бұрын

@@AmreSupply it is more of a heat shield to that front cover. Visited local hoe depot. They don’t have anything. I took out a piece of ceiling and wall fibreglass insulation (like wool) and cut it to match that cover and using that now. I put aluminum duct tape to hold the insulation to that cover. This part directly come into touch with burner fire. I am afraid for carbon leak or fire.

@lkw5699 3 жыл бұрын

Don't forget to clean your flame sensor at least annually

@AmreSupply 3 жыл бұрын

Yes Lori that is another good tip. The steps for cleaning it can be seen here: kzfaq.info/get/bejne/l8yPpLWfy66qp6c.html

@sonnyc3826 Жыл бұрын

the part thats suppose to put water into the air is broken i was hoping for a video on that its so dry in here teh heat makes me sick

@AmreSupply Жыл бұрын

Thanks for watching. We have a couple videos on how to replace parts in humidifiers. kzfaq.info/sun/PLCo9SMjkdWBx-MFZoVpaLiOMOws55rOH4

@NFLYoungBoy223 4 жыл бұрын

My furnace has a metal filter it looks like?

@AmreSupply 4 жыл бұрын

Thanks for watching! You might have a washable electrostatic filter. See if you can read the manual or doublecheck the printing on the side.

@NFLYoungBoy223 4 жыл бұрын

AMRE Supply Thank you and I noticed the operating light I sent illuminated to the filter I even changed the fuses and it still doesn’t work.

@AmreSupply 4 жыл бұрын

@@NFLYoungBoy223 Did it work before the filter was replaced? We do a guide for troubleshooting for a furnace that won't start in this video kzfaq.info/get/bejne/eM9nadRhueDTh2w.html and general troubleshooting tips here kzfaq.info/get/bejne/p7idgdWez7GpqZ8.html

@NFLYoungBoy223 4 жыл бұрын

AMRE Supply no it didn’t work I just seen the light was not illuminated

@AmreSupply 4 жыл бұрын

@@NFLYoungBoy223 If you have no indicator light, and the furnace isn't running at all then there's likely no power reaching the control board. Double check these things in this video first before anything else kzfaq.info/get/bejne/eM9nadRhueDTh2w.html

@jacobsever741 Жыл бұрын

Did anyone else notice that the picture didn’t take?

@AmreSupply Жыл бұрын

Thanks for watching, you are quite observant. Even though the picture didn't click on the phone , that particular shot just happened to be the best take of the entire motion and had better pacing.

@derekh7982 Жыл бұрын

You should replace your filter monthly not every 6months....

@AmreSupply Жыл бұрын

Thanks for watching. 6 months is the absolute maximum but it depends on the filter and how often it is used. You are right that in some cases a replacement is needed every month.

@norahsmith3320 Жыл бұрын

I think you mean six months is the absolute maximum

@AmreSupply Жыл бұрын

@@norahsmith3320 Yes you are correct. That typo is fixed now for anyone reading this after the fact.