Fusion 360. Modeling a SU-34 in Fusion 360 my workflow. Design for 3D printing.

Рет қаралды 1,389

13 күн бұрын

In this video, I show you my workflow of how I model an airplane.
If you have any questions, please leave them in the comments. If you are new to the channel, please subscribe, comment and like.

Пікірлер: 7

@benkonczal4584 8 күн бұрын

Super helpful!!! Keep’em coming!

@i_am_the_void 3 күн бұрын

thanks. i'll try it on practice. i'm very beginning in Fusion, i made an automobile engine and transmission model for 3d printing using only loft, bevel, fillet and chamfer. that was tough. but surface modelling should enrich my modelling possibilities😅

@nigelroche863 11 күн бұрын

This is really good, I do hope that you will show us how complete the model 👍🏼👍🏼👍🏼

@cadbuildflyrc3784 11 күн бұрын

I am going to show how to model more of this jet. It is a very cool looking jet.

@cameroncapone3695 10 күн бұрын

Where do you find those pictures with curvature in it I’ve been looking for bell 206 but no luck.

@cadbuildflyrc3784 10 күн бұрын

Have a look at my video on how to find good plans to model from. When you model the Bell helicopter and you use solid forms, model the fuselage in 2 part. Upper and lower.

@cadbuildflyrc3784 11 күн бұрын

Hello everyone, I invite you to join my Facebook group to learn more about designing, building and flying RC aircraft. Ask questions and get help if you need it or post what you are working on or have built. facebook.com/groups/1213000166068580 To join my Patreon www.patreon.com/CadBuildFly