Thanks for the video, helped me out a bunch. This is exactly what I needed to see in order to get an understanding of the transducer.

Thanks. I have mine on the port side. U changed my life.

Great information. Once again, a learning experience! You always do a great job. Thanks.

Great video!! I sure love my masterclass! This video was very helpful when i installed my lvs34 and 1022

Getting ready to put mine on a pole this weekend great video bud. The video helped so much.

Thank you for making such a clear concise video. I had my transducer faced backwards with cable in front prior to this and knew I had something wrong by what i was seeing on chartplotter.

Good info as usual..I have my lvs34 on pole mount on my kayak. I'm using the Fishing specialties kayak bowducer pole with their 34 transducer mount. It does down, forward & perspective. It's a ram ball transducer mount so you can adjust the angles infinity. The ram mount makes the transducer center below the pole so it has less water resistant & not hanging off the side like a hockey stick. It also has the cord run down through the pole it's completely out of the way, don't need to tie it up. I've been super happy with it so far!

Thank you for this. It was very helpful and well explained.

Thx Randy. Fantastic video, finally I’m 100% sure of what I’m doing 😊🇧🇪

Hoping to rig mine up today! Thanks for the video!

Best explanation I've seen yet!!

Just watched this. I think I get it between forward and down orientation. I'm going to run a front mounted pole like you've got on my boat

HAD MINE ON BACKWARDS!! THANK YOU SO MUCH!! GREAT HELP!!

Well done ! New user of Livescope and I found your explanation very helpful. Thanks !

TY for the informative video. lots of new to me info!

Installing my lvs34 on my yak today. Thanks for this 👍

i installed my this weekend and never could see my bait, if the wire is in the back which notice does have to be in to be in forward view thank you love your knowledge and videos

Great explanation! Thank you.

Good video and helpful information 👍

Great video good job of braking and Explain it

Awesome information and awesome video

Great video! Best one that I have seen.

I see you can adjust the down angle on the summit mount for perspective mode. How do you adjust the down angle on the Garmin 34 mount? It looks square and not angled down, which means a lot to the 20 degree beam will be pointed out of the water and not toward the bottom. Seems you would want to be a able to adjust that. Is Garmin missing something?

I've watched most of the LVS34 install video's out there . This one is by far the best on how to orient the transducer with the perspective mount. Thank you!

Extremely well said. 👍🏻

Thank you so much you are awesome guy and thank you again

Did a really good job explaining on the lvs 34 unless I missed it I think that was the prospective amount that you were explaining would that be the same as a zero mount far if you were in down mode. just got it hooked up taking it out tomorrow hopefully the weather holds up

Great information

Hello love the video, I’ve got the 32 really wanting to up grade to the 34, i fish mainly 20 to 30 feet mainly fish brush piles rarely snipe fish don’t really like it is the 34 really worth the 1200 dollar upgrade thx

Helps a lot

when using a rod holder mount, on the port side gunwal, do I still face transducer forward?

I had it 180 back asswards.

Great job bro. How about a video comparison between the 8 degree offset livescope mount vs the 0 degree mount ?

Good one agin I like it

So by “starboard side” are you referring to which side of the boat the trolling motor is mounted on or which side of the trolling motor the transducer is mounted on?

Good video, have a question off the subject. How can I turn on and off my tracks on a ultra 126sv. Have tried but end up losing all tracks. My screen is loaded with tracks I don't need but don't want to lose the ones I do.

Watched it for the 32 now back for the 34

For bass fishing clear or dirty waters, which way would I need my transducer? Brand new to livescope not sure what I’m doing but you are helping lots, thanks. I just don’t know if I should put it down or front or which one

Great video! With a pole should I be using a flat mount or the slight angle mount they sent with it? Yours look flat to the pole. Also you show going to prospective mode from port side only, which way does it all go from Starboard side? Or should I switch to port then prospective? Thanks for the help that Garmin does not give!!

One more question.... I calibrated my unit and got a 97% on both readings. However, for some reason the cone on the top right corner does not point in the direction that the transducer is pointing. I have done it 6 times and have the same problem. I have done it with the trolling motor and big motor. Any ideas?

Hi my friend how deep the transducer lvs 34 should be in the water ? Thank you for the answer!

When I move to a different spot and pull the troll motor up, do I have to turn anything off?

Is that on the 8 degree angle? Lvs34? I have the seelight 2.0 system and trying to figure out if i should use the garmin perspective mount or do i need a zero degree mount? Or should i order the summit one? Lol. Sorry just bought livescope and 126. Haven’t used it yet.

In forward view on a pole mount is the transducer supposed to have that slight angle up?

Good video can you do some 32 setting video in the future

Is the newer LVS 34 mount that comes with the unit considered a "O degree" mount?

Is that a new mount for the lvs 34 or what? Mine does not look like that. Thanks

I have a question, I'm running a livescope setup upfront and a 94sv at the console. Do I need 2 separate batteries for this setup. What brand of fuse block do you run, I'm trying to figure out what I need for my setup

Do you have a video of this mounted on an Ultrex with 360

Another great video Randy, what brand transducer pole is that. Thanks

Does the orientation on the installation tab have to be on auto or forward?

I am looking for the 0 degree mount you have. I can't seem to locate it. Could you give me the part number.

There are 4 words that should be in the Garmin install literature: "Cord in the back"

Can you install this mounted to the transom for down view?

One question for clarification: starboard/port side of the pole, not the boat?

How far under the waterline do you like the transducer?

I went out and had it mounted with cord in the front and it worked?? Can you face it anyway?

I have fishing specialist mount. No pole in the way to be on starboard or port side. Sooooo let me understand this correct.... regardless of which side I use port or starboard the cable in front or in the back tells me which way to orientate the Transducer.. Cable in front means bottom is parallel Cable in back means top is parallel Also I have used down mode and left it in the same position and adjusted the angle or pitch to make it straight as possible on the installation setup and I believe it was pitch

Does it matter if the transducer is port or starboard?

Can I send you a couple pics of my transducer set up & get your opinion.

So, on I LS v32 starboard shaft mount, can I see under the boat in forward view setting and down position? in down position, how many feet forward can a person hope to see? Thanks

What pole mount do you have ?

On the LVS34 truly not sure of what angle the transducer needs to be set to start.

had to really crank the sound up to hear.

Most ppl ik have to run lvs 34 1 click up. If not I can't see my bait more than 30ft

This is totally opposite of what we we were taught.

What kinda pole are you using if the transducer is not mounted to trolling motor?