Giant Circle Jig? Expanding What Your Table Saw Can Do

Рет қаралды 10,623

FranklinWoodWorks

Күн бұрын

How big is too big? Way bigger than you think.

Пікірлер: 17

@TheVineyardFarmhouse 4 жыл бұрын

A person watching you, definitely learn from the mistakes you make. I would say your mistakes and hurdles, on this project, may have been blessings in disguise. The table looks great. I enjoy watching your videos.

@mikedeafenbaugh5984 4 жыл бұрын

I was on the fence about the idea of contrasting wood filler, but you pulled it off. It looks good!

@sapelesteve 5 жыл бұрын

Nicely done! That round table turned out great. Also liked the way you built that circle jig.....

@christofix 5 жыл бұрын

I think this turned out really good! Nice table top and great to see how you did it !

@inkkroom 3 жыл бұрын

Nice lumber work gee.

@glencrandall7051 5 жыл бұрын

As I mentioned to someone yesterday, "If the result is satisfactory, then the steps to get there are unimportant.". You did good!

@jabrwok 5 жыл бұрын

Paranoia is an irrational fear. There's nothing irrational about being afraid of power tools! Fear makes you careful:-). Nice table top.

@timothyhood2827 5 жыл бұрын

I love the hiding in plain sight idea. Great job and great approach in covering blemishes (even if the blemish was only in your mind!). Thanks

@emostorm7 4 жыл бұрын

Looked great

@jeffb6506 5 жыл бұрын

Nice Job! Two thumbs up for creativity.

@SawDustMakerRJM 5 жыл бұрын

I think the table top turned out really nice.

@walterrider9600 4 жыл бұрын

thank you

@jaytee1205 4 жыл бұрын

Hi I've cut a few circles on panel saw, but there's something I'm doing wrong on a few of them where they come out alot smaller? The nail is in correct position.. I cut 1600mm round and two came out 1300, my question is there a simple mistake to avoid?

@FranklinWoodWorks2016 4 жыл бұрын

I assume "panel saw" means the vertical kind? I'd love to see the circle jig for that. The only thing that I can see that could cause the circle to come out shorter, is if you measured from your pivot point to the leading edge of the blade. That will be a longer distance that from the pivot point to the center of the blade. If you shoot me an email I can draw a picture to show you what I'm talking about.

@jaytee1205 4 жыл бұрын

@@FranklinWoodWorks2016 thanks, I think it may of been my mistake! Appreciate the feedback