Gravely Zero Turn Spindle Removal and Installation This video is just a removal and installation since no bad bearings were found.
Пікірлер: 17
@dboy5207 Жыл бұрын
The best way to get the tension or belt off the pulls would be to use the belt tensioner my friend.
@A_Renaissance_Man Жыл бұрын
Excellent. Thank you, I really appreciate your comment. I need to get one of those tensioner hooks.
@bigdogbrosadventures8371 Жыл бұрын
Good video. I hope your pulley stays tight without torquing that bolt or any blue thread locker. Nice to know the bearings are replaceable.
@grasscutter88 Жыл бұрын
amazing how all this stuff just slides right off. Must be a practically new mower
@A_Renaissance_Man Жыл бұрын
The mower is six years old. My cut time ran down from 2 hours to 45 minutes a session. My yearly hour runs are only 12-14 hours a year. Big change from a 42" lawn tractor to a 52" zero turn.
@garrettlovelady84593 ай бұрын
Remove spring on belt tensioner, belt comes right off
@A_Renaissance_Man3 ай бұрын
Thank you for the great info
@stevanrose743918 күн бұрын
Where did you get those white cotton gloves 🧤
@A_Renaissance_Man18 күн бұрын
Thank you for asking. I purchased them on Amazon. They are sold as coin and jewelry handling gloves. www.amazon.com/gp/product/B086PCDYLX/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
@tsant6591 Жыл бұрын
Exactly. Spindles are cheap enough now, to just replace. The days of bearing replacement are over.
@scotthomberg14111 ай бұрын
Idk about that. I just had to replace one yesterday, cost me $222 for a brand new one. Only 110 hours on the machine
@juny2816Ай бұрын
@@scotthomberg141 Priced OEM on my 48" HD and I think it was 286.00. I'm trying the made in China for 88.00. Might buy the bearings and rebuild the OEM.
@grasscutter88 Жыл бұрын
I had to use a puller attached to those holes to get the pulley off
@A_Renaissance_Man Жыл бұрын
Thank you. Those pulleys are tough to remove.
@martinnakel6088 Жыл бұрын
Good Video - Note there were no grease fittings on the spindles. Why not? Does John Deere have grease fittings on its spindles ?
@A_Renaissance_Man Жыл бұрын
Thank you for asking. There are sealed bearings on these high end residentual zero turn mowers and they should last between 400-600 in-use hours. John Deere, the last one I had I bought in the mid 90's from the dealer and it had grease fittings but the spindles did not last and I am sure that I changed out at least four of them over the years.