Grinding a Flywheel
Рет қаралды 6,236
Жыл бұрынI use my lathe and a Van Norman FG5000 Fly Wheel Grinder to recondition a Flywheel for a John Deere 2955 Tractor.
@edsmachine93 Жыл бұрын
Nice lathe, good idea to true the flywheel in the lathe first. The FG5000 Winona Van Norman is a great flywheel grinder. I ground alot of flywheels on these machines. Nice job. Thanks for sharing. Take care, Ed.
@EngineKrahnicles Жыл бұрын
Thanks Ed. It's also a big time saver and a grinder is super messy.
@stevenandkaiharms6012 Жыл бұрын
THIS IS SICK
@stevenandkaiharms6012 Жыл бұрын
Is this a special lube or coolant being used? Or water?
@EngineKrahnicles Жыл бұрын
I use water and add some of the Goodson brand flywheel grinding solution. Good results and no rust.
@DrivelineMaster 8 ай бұрын
Why did you cut it on the lathe if you still needed to grind it? After watching the grinding it was obvious the lathe didn't produce a flat and true surface.
@EngineKrahnicles 8 ай бұрын
Because the grinder take about 5 times longer than the lathe. I only use the lathe if .015 or more needs to come off. It's a lot faster, even with additional setup. With the lathe, I'm mounting in on thr ring gear surface, which isn't true. On the grinder, it's on the crank surface. I'd say this one was .002 off.
@DrivelineMaster 8 ай бұрын
Thanks for the reply.
@dustyroads834 6 ай бұрын
I don’t think the flywheel was true int he lathe. The hit and miss at the beginning where the flywheel was never worn tells me this. I’m sure the grinder corrected it.
@EngineKrahnicles 6 ай бұрын
Yup, I'm just using the lathe to rough it, and the grinder cuts it flat
@stevenandkaiharms6012 Жыл бұрын
First like
Gufee.medalin
Рет қаралды 10 МЛН
Amazing thing official #2
Рет қаралды 32 М.
Wondering Skills
Рет қаралды 103 М.
jamoloniy
Рет қаралды 946 М.
Mexican Catel Jet #automobile #car #racing #fun #performance #meme #police #cartel #comedy #jet #cop
Motorhive
Рет қаралды 2,8 МЛН
# мотоТаня
Рет қаралды 6 МЛН