Harley Davidson Front Engine Mount Replacement

Рет қаралды 2,265

Күн бұрын

Front Engine Mount Part No. 16207-79D $102.06
Located a service bulletin dated 12/01/2005 where it showed the updated engine mount from the previous 16207-79B to 16207-79C. Of course it would appear that they have updated it again to 16207-79D. According to the bulletin the engine mount retrofits touring motorcycles manufactured since 1980. As always, verify that you are using the correct part for your particular year, make, and model.
Replacing front motorcycle engine mount on this 2006 touring motorcycle. You can perform this job without using a motorcycle floor jack as long as you can get a jack underneath the engine to raise it up to get the old mount and new mount in place. In this video I am utilizing a motorcycle jack due to not having a floor jack that will be able to fit underneath my motorcycle along with attempting to get better video of the underside of the motorcycle. If using a floor jack please be careful when raising the engine not to tip the motorcycle off the jack stand. You may want to secure the motorcycle to the jack stand with a strap along with placing wood blocks underneath the front and rear tires of the motorcycle to prevent the motorcycle tipping off the stand.

Пікірлер: 7

@altoncrossno1333 18 күн бұрын

Good explanation on the change of the mount

@user-bl8bn4kb8m 2 ай бұрын

Alot of people put the mount in wrong assuming the other side goes on top because the old one has the other side on top.

@Old940 4 ай бұрын

Very good video.

@kennethayers5624 4 ай бұрын

By far...the very best and most informative video on replacing a mototr mount I have watched..Have a 07 Street Glide so this is about perfect for me...Thank You so much...Also,did you torque the two bolts you just loosend on top or just normal tight?

@cheapjoker3321 4 ай бұрын

I am thinking I probably just tighten them down since the oil filter was in the way of one of them.

@brianbeam2570 8 күн бұрын

Good video brother, Question how did you know you need to change the mount, my 06 SG makes a clank when i go over bumps, so i can only think its the engine mount. thanks again for the very good explanation

@cheapjoker3321 8 күн бұрын

At the time it seemed to me that I was having excessive vibration and so I just checked it as a means to try to remedy it. As far as clank it possibly could be the engine Mount. I know a car is different but I had a vehicle where you would go over set railroad tracks you would have a clank and sure enough it was the engine Mount.