Honda doesn’t cover Carburetor warranty 👎🏼

Thanks! This wasn't the exact same as my 10 year old mower, but close enough that I could get it back together again.

Outstanding lesson on the assembly of the carb. I bought two M6 X100 mm bolts at the hardware store for $1.39 each and cut the heads off to use as stud guides.

This video is so helpful. I took my carburetor off and all the gaskets / parts fell down and I couldn't be sure of the right order of parts.

Thank you for clearly explaining from the get go that this video is NOT for my manual choke fixed throttle GCV160 carburetor.

My GCV170 is having the same rev up / rev down issue so I'm gonna give this a go and hope it's 90% accurate. :)

Thank you bro I have the soft gasket instead of metal one and I was so confused when I took it apart lol

Very Good Video. As a small engine mechanic and owner of my own business, North Valley Repair and Small Engine Services I have found that these GCV engines are the hardest to work on. My recommendation is alway use SEAFOAM or a real good fuel conditioner and stabilizer and run the machine with fuel off to keep the carburetor.

Going to add an inline fuel filter to mine after stripping it down and cleaning it again. Should prevent future tear downs 🎉

I should have taken a picture first. This was incredibly helpful. Thank you.

Thank you that was very informative especially the two stud bolts❤

Thank you for the video!! My idle when the blades weren’t engaged surged and surged. Took about twenty minutes to get the carb off, cleaned, and back on with your help. Mower runs like new again!! 🤙🏼

Your video is very useful; thank you for posting it! I'm going ahead and using two old chopsticks in place of the metal studs for carburetor installation purposes. This saves time and money.

You need a jis (Japanese industry standard) screw driver to remove that screw. easily found online. Funny most Japanese cars like my Toyota have many of these screws which look like plain old Philip screws. I'm sure many people stripped many of these not knowing this.

@dad's workshop... can you look at this and tell me how to remove the #1 screw that is to the right of where you worked? You remove two of the three in the video...but I want to understand what that other screw is and how to remove, clean, and replace it...Thank you for a great video..with wonderful music.

good video

I stripped my pilot screw on my HRN mower. Is it the entire carburetor completely shot and need replacement? It was not budging when I try to screw it off

Just another FYI comment. Honda will be discontinuing the HRR , HRC and probably all other Gas Lawn mowers by the end of this year and next year. They , as well as many other manufacturers, are going cordless electric.

what to do if I forgot to count the throttle stop screw threads?

The only problem with HONDA is that not all GCV engines were the same for carburetors... The GCV160s and 190s on pressure washers are totally different than on lawn mowers

3:40 How does just spraying cleaner actually clean it out? Awesome video btw.

Great video. Whoever designed this carb mount though must have been on LSD. I had many problems with it and had one big problem. I ordered the studs from Amazon and I didn't notice it right away but there is a ridge on them close to the thread that threads into the crankcase where there is a larger circumference that extends for about 3/8 on an inch. I assume this must be for a retainer of some sort. But the ridge jammed in the rubber carburetor flange and would not come out. I had to completely disassemble it and grind the ridges from the studs so they would go through the holes in the rubber flange. After that I was able to use the studs to reassemble it. But I would not have been able to do it properly without the video. Thanks.

Hi, good video. What is the length of studs?

I shoulda bought a Craftsman 😢

Not sure why you skip so many areas