LIKE | SHARE | SUBSCRIBE Honda Jazz Headlight Bulb Replacement. Honda Jazz Bulb Change. Honda Jazz Headlight Removal Process #jazzheadlightbulb #jazzheadlightremoval #jazzheadlamp
Пікірлер: 101
@pianothatilove Жыл бұрын
Thank you very much for the video 👍
@diykhan Жыл бұрын
You are welcome thanks 😊
@davidmingay Жыл бұрын
This is an interesting method. I did it differently by reaching round the back, pulling out the plug, removing the seal, undoing the clip, replacing the bulb, and putting it back together again. No tools required, and it only took less three minutes.
@BerndtTost2 жыл бұрын
I had a 2003 Jazz. I changed the headlight bulb by accessing it through the wheel well. To change the right hand side turn the steering wheel full lock to the left. Go to the wheel well. Remove the positioning lugs that hold the splash guards in the wheel well. You will have enough room to access the headlight bulb and replace it. Then replace the splash guards in the wheel well and to the same for the left side but with full lock of the steering wheel to the right. No need to disassemble the front bumper and headlight assembly.
@MarkHarmer2 жыл бұрын
Going to try that first! Thanks!
@AN-ix9lg Жыл бұрын
of course! :)
@surfsusi Жыл бұрын
Ich habe das auch so gemacht aber über den Radkasten ist es ein ziemliches gefummelt und zum Teil muss man blind arbeiten da es nicht sehr gut einsehbar ist.
@nikolaanker5222 Жыл бұрын
Ich hab es eben über den radkasten gemacht es war nicht einfach aber ich hab es geschafft. Allerdings habe ich auch kleine Hände. 😃
@ellabennett450410 ай бұрын
Thank you!!!
@MagicWok Жыл бұрын
Well done Honda on designing a really annoying way to replace a bulb that super easy in many other cars.
@angelojosephhh Жыл бұрын
Thank you Mr Khan. U helped me to do lamp replacement job so easily and saved .e couple of 100 dollars
@diykhan Жыл бұрын
You are welcome thanks
@juliangall2 жыл бұрын
So helpful. Thank you very much. Just been sitting out in the wet road following your instructions. New bulb now successfully fitted.
@nesperndlovu59538 ай бұрын
😊
@cchplays81822 жыл бұрын
Great video, with your help I just changed the sidelight on my 55 plate Jazz....I tried pulling the wheel arch fairing down but could not get my hand in.....so I took the entire lamp out as per your advice.....Excellent, job done thank you very much.
@diykhan2 жыл бұрын
You are welcome thanks
@christophersmith78912 жыл бұрын
Great video! Had to change 2 bulbs now and watched this video both times. Thanks so much 🙏🏽
@diykhan2 жыл бұрын
You are welcome thanks
@markpeti2 жыл бұрын
Helpful video thanks, I changed the bulb without removing the lamp. But I wouldn't be able to do it without watching the video as there is not much space so I did it by touching rather than looking, but as I say seeing on the video what needs to be done was much help
@diykhan2 жыл бұрын
You r welcome
@sambacko4188 Жыл бұрын
Thank you DIY Khan. Was very easy using your method. Worked a treat 👍🏼
@diykhan Жыл бұрын
Thanks
@thefiremandave910 Жыл бұрын
Thanks for this. I did it today. It was much easier after watching the video.
@diykhan Жыл бұрын
You are welcome 😊
@frenchy6254 Жыл бұрын
I’ve just used your video to help me change all 4 bulbs. It was an awesome video and can’t believe you don’t have more likes. Thank you so very much for taking the time to make this. I hope you have a great festive season. From Keith in the UK.
@diykhan Жыл бұрын
Thanks for your best wishes. Have a lovely Xmas
@ivelin8886 ай бұрын
Very comprehensive, thank you!!
@diykhan6 ай бұрын
Thanks 😊
@aidanh5215 Жыл бұрын
Thank you so much (in advance) Mr Khan. What an insane palaver I've got to look forward to...
@aidanh5215 Жыл бұрын
Done. Thanks to you. Who designs this idiocy?
@diykhan Жыл бұрын
Good
@ismailali32505 ай бұрын
Keep up the videos very helpful earned a sub
@dreddy025 ай бұрын
The Jazz manual, explains it, you just go in via the wheel well, remove two clips and your in to the back of the light,, no need for all this malarkey! ;o)
@btinternet0092 ай бұрын
Good job thanks
@Misiunass2 жыл бұрын
Well done. Thank you very much!
@diykhan2 жыл бұрын
You are welcome thanks
@Sir_Veza5 ай бұрын
Muchas gracias, amigo!!
@diykhan5 ай бұрын
Thanks 😊
@jeshlee Жыл бұрын
Thanks mate. Very helpful
@diykhan Жыл бұрын
You are always welcome 🙏
@thepoofication4 ай бұрын
Just for info: I was able to do this on the driver side without complete disasembly, was very tight and you need to be relatively dexterous with you fingers. I have medium sized hands (181 cm). Maybe it's usefull to some, so like the comment for others.
@artcartoonworkofficial3 жыл бұрын
Good work ilike I'm new friend sappurt you
@ismailali32505 ай бұрын
If possible pls make more vids on the jazz thank you
@ismailali32505 ай бұрын
Thanks for these videos
@JustWilliams2 жыл бұрын
Great video. Thank you.
@diykhan2 жыл бұрын
You are welcome thanks
@scorpiistar Жыл бұрын
great video m8 thankyou 🔥📈🔥📈🔥📈
@diykhan Жыл бұрын
You are welcome thanks
@a.r.7699 Жыл бұрын
You are Master!!!!!! 👍👍👍👍👍👍
@diykhan Жыл бұрын
Thanks very much 👍
@wuseling8 ай бұрын
...well I always change them from behind (blind) ... the bulbs often fail (2009 model, maybe there is more space)
@ibrarali9369 Жыл бұрын
Thanks, good explanation 👍.
@diykhan Жыл бұрын
You are welcome 😊
@nikolaanker5222 Жыл бұрын
Thank you so much for this Video 🙏
@diykhan Жыл бұрын
You are welcome thanks 😊
@itx_me_hassu133 жыл бұрын
6 Lk Amazing ♥️ Stay Connected
@diykhan Жыл бұрын
Thanks
@haniraja13 жыл бұрын
Very well done sir g
@diykhan3 жыл бұрын
You are welcome thanks
@TheSpannerLab Жыл бұрын
Thanks buddy.
@diykhan Жыл бұрын
You are welcome thanks
@philvan4113 Жыл бұрын
Thanks for the video
@diykhan Жыл бұрын
You are welcome thanks
@kdz67753 жыл бұрын
Thx my friend
@diykhan3 жыл бұрын
You are welcome thanks
@12345anser6 ай бұрын
just changed both bulbs from wheel side for left bulb turn wheel full to right .....and remove 2 studs with screw driver by simply plying out....then push down the mud guard and put arm in and feel instead of looking....remove cable then remove rubber then remove clip by unhinging the clip outwards....then remove bulb....replace new bulb by turning round till it fits in hole and put clip back...then put rubber back and plug cable same with right side ..turn wheel full left...then start remember to wear gloves if possible ...and turn car off to avoid charging yourself😅
@dario-em9lc3 жыл бұрын
Thanks 😊
@diykhan3 жыл бұрын
You are welcome thanks
@waschbaers_werkstatt Жыл бұрын
Thanks 🔧
@diykhan Жыл бұрын
You are welcome thanks
@amnakhirdtechvlog84703 жыл бұрын
Good video nice I like it Full watch nice video great I like it Amazing ♥️ Stay Connected good idea
@diykhan3 жыл бұрын
You are welcome Thanks
@Michael-dp4fo Жыл бұрын
What size is the side light?
@jilumiah Жыл бұрын
Thanks man really helped, but what awful design by Honda.
@diykhan Жыл бұрын
Yes true 👍
@saiedaltinawi69142 жыл бұрын
Super
@diykhan2 жыл бұрын
You are welcome thanks
@JakobusVdL3 жыл бұрын
Phew, that looks fiddly! Honda didn't plan on the headlight bulbs being changed easilly. How do you check the headlight alignment is correct after fitting?
@fionatinker23 Жыл бұрын
Agree - I am watching this in horror! Mr Khan makes it look easy, which shows he's a master craftsman. He takes his time, explains it all clearly. Whoever at Honda HQ thought this was a great design for a headlamp is most certainly not a master, more a sadistic novice! I'll have a go but I can see this being a garage job. Just to change a b****y headlight bulb.
@JakobusVdL Жыл бұрын
@@fionatinker23 Hi Fiona, I did the bulb change on my daughters Honda Fit. I did it in a few hours on my drive. I found that taking the whole nose panel off the car, then rmoving each headlight unit off, and then changing the bulb was straightforward. and I took the chance to clean the chassis, radiator etc, and give the headlamp lenses before putting it all back together. I turns out headlight alignment wasn't a problem it all seems to go together with no adjustment. So if you have the time, and a set of screwdrivers and sockets, it is straightforward. However, the person at Honda who designed that set up still owes me a pack of beers - so impractical.
@fionatinker23 Жыл бұрын
@JakobusVdL thank you for the encouragement. I will try at the weekend. Such a simple thing shouldn't be so complex though. I like the idea of cleaning underneath too. Good tip.
@JakobusVdL Жыл бұрын
Great@@fionatinker23! Let me know how you go.
@fionatinker23 Жыл бұрын
@@JakobusVdL I've wussed out! The bolts and screws are really tight and I don't have the strength in my hands to give it a good enough whack to loosen. WD40 laughed at me and noped out :-) Plus, it is snowing and freezing, so I am just going to be a pathetic eejit and take it to the garage on Monday. I do - very much - appreciate your helpful comments and Mr Khan's great videos though. Have a lovely festive season, both of you.
@adammillsindustries.3 жыл бұрын
Nice. I guess side light just twists out?
@diykhan3 жыл бұрын
Hi Yes thats just a twist out type
@silverback15402 жыл бұрын
Thanks mate like & sub
@diykhan2 жыл бұрын
You are welcome thanks
@jojojohanes33103 жыл бұрын
Good job, but no need to remove headlight to change light bulb
@diykhan3 жыл бұрын
There wasn't much space behind or a window in the wheel arch to get to to build Thanks for your support
@RadioNul2 жыл бұрын
Wheel arch method is near impossible
@jojojohanes33102 жыл бұрын
@@RadioNul I agree not an easy to do blinded from the wheel arch but if you know where to press and what to unhook than it’s not that hard. When I change it next I will make a video from it. Good luck in changing
@diykhan2 жыл бұрын
Yes i agree. For beginners it's a mission to change a bulb from under the wheel arch
@sambacko4188 Жыл бұрын
Tried wheel arch method and couldn't do it. Tried your method and took 10 minutes and was very easy. Thank you very much Khan :-)
@phd6502 жыл бұрын
Pas besoin d'enlever le pare choc lol y a de la place