Check out this short video on how to run a 6010 (or really 6011 too) in the horizontal position. Keep in mind travel and work angles. Overall not a difficult weld to make!
Пікірлер: 7
@davidn1374 Жыл бұрын
I've also heard always go bottom to top or you can get under cut gaps between your welds
@watupchief58893 жыл бұрын
Awesome weld content 👍🏽
@weldzcool11473 жыл бұрын
Thanks 😁
@bobmoffatt41333 жыл бұрын
Very nicely explained and demonstrated. Progression from top to bottom?
@weldzcool11473 жыл бұрын
The video footage was top to bottom but at the end there is a photo of both top to bottom and a bottom to top. So can be done either way. 😁
@capsquadgaming Жыл бұрын
arnt ya supposed to go from bottom to top when you weld horizontal