I just installed my second mounting system on my adjoining bench. I have a LnL Classic press on one mount and a Lyman All American 8 turret press on the new one. I also have 2 extra plates that I haven’t used as yet, but I have the Cam Lock Case Trimmer and the LnL Neck Turn Tool that are prime candidates. I had to lose 2 drawers on my benches, as the press handles lock these drawers l but I didn’t have much in there anyway that won’t fit in the remaining 6 drawers. I’ve heard some negative feedback on the Case Prep Trio, but so far, mine is awesome, if not a bit noisy. Since I have the Single Stage Primer Pocket Swage Tool, I put a .30 Cal brush on my trio, along with the inside and outside champfer tools. Cleans out the brass chips that get in the cases while champfering,

so why don't you use case pilot in the cutter

Killer setup man I'm interested in getting that Hornady bench plate setup. I've got a concentricity tool that uses the same body as that trimmer and a neck turning machine that uses the same body as well.

some people need to learn to read the instructions

that camera work hurts my eyes !

Prep trio is junk, I had two go bad very quickly because the gears are crap.