We are making trim from PVC coated aluminum coil stock and wrapping the brick molding on the doors of our Legacy Block ICF House. #concreteconstruction , #sheetmetalfabrication , #doortrim
Пікірлер: 4
@PineyWoodsHomestead10 ай бұрын
The finished product looks great and every time you look at it you'll be reminded of how challenging it was to construct. I probably would have been cussing while trying to bend that metal. Good job Tony!
@ozarksethic10 ай бұрын
Thanks. I thought it turned out OK for a neophyte. Bad words are why editing is important! They did occur when I forgot a bend or went the wrong direction. Thankfully, that only occurred twice... The bending was less stressful than fitting it since you have to worry about scratching or denting it and a wrong cut means making a new piece. Overall, I'm glad that's done.
@rickc431710 ай бұрын
I didn't know this capability existed, and obviously never seen it done. Amazing stuff, Tony. Thanks for the info and lesson.
@ozarksethic10 ай бұрын
Thanks and you're welcome. It's actually pretty common around here. Our contractor bent quite a bit of stuff to do the soffit & fascia. I'll show some of that in the upcoming roof video. It was more of a "this exists" than a lesson but I'm glad you enjoyed it.