How Long Will it Take to Clean my Silencerco Hybrid 46M in my Ultasonic Cleaner…..??

Рет қаралды 3,857

Kentucky Range Time

5 ай бұрын

Doing a series of test runs to determine how much time to clean these parts.

Пікірлер: 15

@Anthony-reborn 12 күн бұрын

I use hoppes numner 9 and charcoal lighter fluid for cleaning solution and i leave it in for a couple of hours. That will get that metal shiny on the inside.

@dads2006gt 2 ай бұрын

I use a large ziplock freezer bag. Put simple green in the bag with the suppressor and parts. Fill unit up with hot water and place bag in the water. This process did an amazing job cleaning my silencerco hybrid 46m. I ran the ultrasonic cleaner for two cycles of 15 minutes each. I have the 15 L Creworks. Heat setting on it works great.

@lousmith5264 19 күн бұрын

Temp is important in cleaning reaction time. For every 10 degree increase in temp, you double the physical chemical reaction. This is proven for all chemical reactions.

@Anthony-reborn 12 күн бұрын

I also recommend standing the can upright instead of on its side. Because of how the sound waves moves the fluid itself inside the cleaner.

@kentuckyrangetime 12 күн бұрын

My tank isn’t deep enough. 😢😉

@Anthony-reborn 12 күн бұрын

@@kentuckyrangetime I got the same one as you. Just flip it around every so often

@djtlfox 19 күн бұрын

How did u get the baffle strike?

@kentuckyrangetime 19 күн бұрын

I’m still not sure. SICO didn’t even offer an explanation either which is frustrating…. I’d like to know for sure so it doesn’t happen again. lol The only thing I can figure out is maybe the Neilson device 🤷🏼‍♂️?? I’d ran this on 6ARC, 5.56, .300blk, .458socom and .22LR with no issues but that 9mm…. Both barrels checked out good with the bore alignment rod and the Neilson Device is the only variable that was different.

@BrimforBreakfast 4 ай бұрын

I was under the impression it was a sealed can and it couldnt be cleaned like so

@kentuckyrangetime 4 ай бұрын

The baffles are welded in and can’t be removed but the ends are both open to take different adaptors and end caps with different bore openings

@arthurdsoto5751 4 ай бұрын

Why are you getting Baffle strikes? I have an Omega 36M & I haven't had that happen.

@kentuckyrangetime 4 ай бұрын

Honestly, I’m not real sure. Silencerco wants me to send it back so they can evaluate it though so I guess I’ll have to wait on them to tell me. I’ve tried 2 different threaded barrels and got strikes with both.

@arthurdsoto5751 2 ай бұрын

@@kentuckyrangetime I'm sure they will figure it out for you.

@5shotgroup451 2 ай бұрын

I thought silencer Co uses a clipped baffle design? Because that's what that looks like to me

@kentuckyrangetime 2 ай бұрын

@@5shotgroup451 they do, but deeper in they are bent even more on 1 side. 😢