Enjoying your videos great job as always bud

This Geeza is the bollox would love to work with him for a week . I’ve commented in the past on one of his posts and got a great reply too bloke . But I’ve been plastering for 15 years also done a quite a bit of lime work on listed buildings but I’m loosing alot of work as I haven’t tried silicon render yet really need to do it but I do sand and cement work got a job next week that would be ideal for thin coat customer had someone in who done monocouch and cocked it up now They want me to do all sand cement instead . Plus I got 2 houses need rendering in next month wish I could do thin coat need to try it . Keep up the videos mate best plastering videos on here 👍👊👏💪💪💪

Great job mate. Can u tell me what the background is. Cheers

have you got any vids on applying back coat over 6 mm beads mate?

Have worked with all the acrylic finishes for 20 years here in the states the depth is determined by the size of the aggregate in the finish,a small amount of water is good 4,6 oz and if it's a hot day 25 c or above 2 men on each lift will make life a lot easier, priming the wall before finishing is key stops pin holes and kills the suction 👍

I prefer spraying also I've bennu x15. But only problem with spraying needs to tape up like a forensic site. Hand applying tape also but not as much as spraying

How easy is it to remove ? Is there a chemical I could use ? Any advice great fully received

How long do you leave the base coat to dry before applying the thin coat?

Good advice as always. I use mostly baumit thincoat and Vpi. But I think baumits the best personally. Basecoat I really like also Kzp 65 Starr contact Mc55. Great stuff

what size render beads you use 5mm?

That must really brake your trowel in buddy.. 💪

Legend mate. I was struggling like fcuk with this stuff

What brand you using bud and does that accelerator cut down working time or cure it quicker I’ve been court out with top coat with rain getting to it the day after

Hi mate so are you just putting on a small trowel full then open trowel to take it all back to a paint like thickness with aggregate and colour left behind? Cheers dude 🤜

Your technique is great , and the finish looks great too! But please can you tell me what products you are using, what is the thickness of the basecoat, does this need scratching, what tis the thickness of the top coat and what is the timescale between the application of base coat and top coat ? And finally does the product you are using come in various colours like 'K' Rend, or does it need painting afterwards? Many thanks

Hi I would like to send you a few videos to see if we do the samething in my country How do I send them to you

🤣😂🤣 U must have about £40 on your 💪, As Always Great detail in your vid's

Can I put this over a sand and cement rendered chimney?.

Your not a plasterer