How to bleed Nissan ATTESA system

No video

How to bleed Nissan ATTESA system | R32 Skyline GTR

Рет қаралды 6,373

Platoon Garage

Күн бұрын

Пікірлер: 38

@itsRAMBO604 2 ай бұрын

Thanks helpful video! The shop thought my reservoir was clogged😂

@PlatoonGarage 2 ай бұрын

👍

@Goodezilla 2 жыл бұрын

Great guide man! I'm about to do this after replacing my clutch!

@PlatoonGarage 2 жыл бұрын

Thanks Dustin. It was a lot easier than I thought it was going to be 👍

@godzillaresurrection8986 3 жыл бұрын

Timing couldn't be better, I'll be doing that today 👍

@PlatoonGarage 3 жыл бұрын

It really isn't too bad. good luck!

@geddy300 2 жыл бұрын

Thanks alot very helpful...keep them videos coming 🙌

@bfighter125 3 жыл бұрын

You kinda look like that guy, that play's The Mandalorian, and also the viper from GOT.

@PlatoonGarage 3 жыл бұрын

This is the way. You should also check me out in Narcos!

@marcopennisi3376 Жыл бұрын

Hey that jumper plug did work for me but I had to unplug then turn the ignition on and off, the method you used didn't work on my car. Great video though 👌

@PlatoonGarage Жыл бұрын

Nice, good alternative to have in case the first doesn't work

@yadier713 Жыл бұрын

Great Video!!

@BourneThisWay Жыл бұрын

What do you mean by “jumper”? Is that the white connector? I recently got an ATTESA error code 8, and I know that’s the ABS motor actuator, but I’m assuming it’s because it’s dry. I’ve had a leak in the high pressure hose for over a year where it connects to the actuator on the diff.

@PlatoonGarage Жыл бұрын

Correct, it's the white plug

@shus369 Жыл бұрын

Hey brotha so I just found out my pressure switch on my 32 is leaking. Is it possible to replace it while it's on the car?

@PlatoonGarage Жыл бұрын

It's not impossible, but pretty close. Attesa system is on top of the diff and is really tucked away, it's probably best to pull the diff

@jonathantheori7541 4 ай бұрын

What was the reason your attessa reservoir was dry if U had no leaks??

@PlatoonGarage 4 ай бұрын

Replaced all the old hoses

@kemosabe8313 3 жыл бұрын

What silicone lines are those that you are running from that reservoir?

@PlatoonGarage 3 жыл бұрын

Lines are a kit from RHD auto design

@xuzm 2 жыл бұрын

which oil did you use for atessa system resovoir and which one for the transfer case? The manual says "nissan matic D" for Transfer case and "Nissan power steering fluid" for resovoir to the atessa system

@PlatoonGarage 2 жыл бұрын

attessa system uses atf fluid. nissan recommends their "matic-d" fluid. I purchased a matic-d equivalent

@xuzm 2 жыл бұрын

@@PlatoonGarage ok, i went for motul atf, i saw it was matic D and dexron compatibile

@PlatoonGarage 2 жыл бұрын

@@xuzm definitely don't need to over think this one. This is a 30 year old system that was just a basic hydraulic pump with an electric controller

@xuzm 2 жыл бұрын

@@PlatoonGarage ok, well I did haha. Wasnt an easy task to find oil with correct specs. Then motul should be fine I belive.

@xuzm 2 жыл бұрын

@@PlatoonGarage thanks!

@IxtheDuckyxI Жыл бұрын

What oil is used here? Power steering oil?

@PlatoonGarage Жыл бұрын

ATF

@Dickusification 4 ай бұрын

Old school remote reservoir hydraulic system. A bit like an older aircraft. Lotsa potential for leaks in lines etc. Most hydraulic actuators now have their fluid and pump all in one unit with the actuator and are electro hydraulic typically.

@kevboost 2 жыл бұрын

is the sound at 5:00 your attessa pump or the fuel pump?

@PlatoonGarage 2 жыл бұрын

That is the attesa system pressurizing 👍

@kevboost 2 жыл бұрын

@@PlatoonGarage really?? My car makes the same noise every time I turn the key to that position, but my attessa dosent work. This whole time I thought it was the fuel pump priming.

@PlatoonGarage 2 жыл бұрын

@@kevboost pull the kick panel and unplug your jumper after the car has been sitting for a few days, if it make the same noise, it's your attesa

@kevboost 2 жыл бұрын

@@PlatoonGarage alright thanks man, love the videos man