He or I should say "she" is a spoiled turd. We thought for sure she was gonna be a rooster when she started chest bumping the big turkeys... naw just a tough broad.

Thanks 👍

I had a little fun with this one. lol

That'd be like swimming in a school of Jelly Fish. lol

I wish I found something like that

I must say it took me a minute to figure out how to get that sucker to stay. It's not like I can just glue it in permanently.

@@PoleBenderFishing He he. I was thinking that if you get the eye-screw out you could perhaps shove some cut to tightly fit insulation thru, so it sits against that cap, and then run a too small drill through the cap. This should also get you better hold onto the chemlite. ( A fitting cork could be used in a new lot. Watta Hail... A cork may not even need glue, and would probably eliminate need of that cap as well. That long chemlite looked 4 or 4.5mm... ( Both sizes are sold ) The corks on my home-made bite indicators hold on to both sizes pretty damn well. As long as you do not make the hole too wide.. ( However... The tape also works, so why bother? ) 🤓

Much appreciated!

do you know of any small lots 5acres or less close corp of engineers boundy to lake close to theodosia?

No, not personally. There's still property for sale around but the land rush pretty much bought up all the good plots. A developer is building a +300k subdivision in Diamond City. Insane...

I've heard of that

Hi there. Years ago I fixed some pipe insulation onto a post to let a shed door bump into (no noise, no scratches). This gray stuff has been exposed to weather for years now, and it still does not crumble. It figures that it held up because of intended use. However, I recently found that a spunge (brownish coarse cells) disintegrated when I started to use it. ( It looked new but was years old.) So your warning is spot on for inferior materials. I also use pipe insulation to store surf fishing rigs onto and seal the slit with ducktape so my tacklebits do not get glued into that. (slit stays usable). Insulation used as floating material on dipnet pole got duct-tape covered. (My net does not sink in the drink when both hands are busy fighting a fish. ) In any case, better safe than sorry, so protection can be used. Pipe insulation is made to fit pipe but may have a too thin wall. But one can put bigger diameter over as second layer, and secure it with duct tape. Kind regards, Jaak. (edited for clarity)

I use duct tape for my tags as well. Hadn't thought of wrapping the jugs though... hmm

@@PoleBenderFishing The "spunge" looked new but was old. 't Was a good thing I did not have a dozen of those. And yes, my long net pole gets a float shoved onto, made of two layers of pipe insulation. FreshWater Soul's comment made tons of sense.