Right then John, you go through he drawers and ill have a mooch in the other rooms....

Since it's easy for a burglar to snap a handle and gain access to a cylinder, do you think it would be a good idea to weld the outside handle to the door instead of letting it be fixed by screws? Provided that you can still change the cylinder when needed by removing the plate that's on the inside of the door and then removing the cylinder from the inside.

Wow You need to be using tct hardplate drill bits You made that look like hard work!!

You made that hard work..

Would definitely advise checking to see what sort of cylinder you have first before attempting to drill, you wouldn’t stand a change if you were drilling a 3 star cylinder

Shouldn’t u have the hoodie on for this procedure?

Surprised he never just panned the window in 😂

your bit needs sharpening buddy. I understand your title.. BUT, I PRESSUMED..if you were a locksmith, YOU DID PICK IT FIRST..and after failing , you resort to that drilling. i am not really sure if you are a locksmith..or maybe just a neighbor who want to help a fellow neighbor. in that case, good job.

Wait.. that's my house

Thank you.

Time to rob a bank

Do you use the same size drill bit from start to finish?

Lol that’s a masonry drill bit 😂

I see this man is not subbed to lock picking lawyer I see why now

Best bit to use is cobalt.

What are the best drill bits mate, I've lost keys for patio door so I'm going to have to drill it out

Would have been quicker to drill it with a cucumber 😂😂😂😂

Look at all the (clueless) experts, this comment section is hilarious.

Never use normal cilinder lock, use a strong smart lock like the Bold lock

was that a masonry drill bit ? it looked like it was hardwork

why wasn't it just picked?

My drill broke inside while doing this,is there a way to open the door?

This ploker is using a wronge drill bit

Yeeehaaa 🤠🤠

Piano b

Every time i have tried it will always brake the bit

You could have just lock snapped that.

Pliers!

lol

Do not drill key hole

Can u even drill?

I've done this and there was more than 2 rows of them pins, I tried each step of the way to open it and now after drilling till all are out, I still cant open it 😭🤣😭 HELP

Snap it much quicker

Idiotic comments. He had to get in, he happened to have that drill bit and that machine. Job done, mission accomplished. Just get a life you silly people.

Lock puller would of been quicker

Just smash the window..

Or just smash the glass

2 mins to pick that lock - This is bad,

My lock is 6 cylinder, been drilling for hours and I can turn the barrel freely and even get the lock to go up and down but can't get it to turn to the position where I can slide the whole cylinder out. Any ideas?

This is very worrying. Hardly save. Camera action smile. You no the drill

Give a guy drill and he thinks he is a locksmith. This is an unprofessional, amateur technique on breaking into a house. Turn yourself in.

Really shouldn’t film yourself breaking in someone’s home

This comments section was too witty and intellectual for me. The method, however, worked just fine. Thanks.

He calls himself a locksmith ? why didn't he pick the lock open ? it's only a standard 5 pin would have only taken 30 seconds

That’s not drilling, that’s drilling and picking. Nobody has those tools which is why everyone was searching for “how to drill open a lock”

please dont do this,call a locksmith

What a plonker! Show every thief how to drill a lock! Why would you even drill this? A locksmith would pick it open! Or use a decent drill bit! Struggling a bit there!!

Amateur!!😂😂🤣