Thanks Peter, fixed old Freighterliner Truck wipers following your advice, great video , thanks

Exactly what I needed-can't thank you enough!

thanks a lot! for all your instructions! tomorrow let me open my Pajero 2005!

you are a very skillful mechanic, all the best ...

I always watch this if i can't sleep. IDK why but dudes voice makes me sleepy. ASMR

Thank you so much Man, I did the same and helped me Really appreciate it❤

Great master! Grettings from Esmeraldas Ecuador

Thank you very much your video is great 👍

Excelent video !!!! Thanks!!!

Thanks. I will try it tomorrow. Regards

thank you for sharing all of your videos are very helpful

Superb idea 👌👍

€5 link repair clip works a treat ! Almost like it was made for the job ;)

very good job!

Is there not still slop between hole in the arm and the ball joint? I did something similar but made a nylon bushing to go between the hole in the arm and the ball joint which eliminates all play. It helps to have a lathe.

practical and very funny !!!

Thanks Peter Finn

good video :)

hi, i got same problem, motor works fine, wiper arm ( whitch moves it all around) works fine, put this joint drives me crazy, it jumps off and windshield wipers stop working cuz they get disconected from motor, i will follow you guide ant try to fix it

thanks good video

Tankyou Secaucusfully

Nice video 😎👏👍

What size BOLT AND nut u used to put motor back together

Its like u tell secrets mate

I've just replaced the linkage on my car and now the sweep on the driver wiper is a bit too long, my wiper hits the a piller and the lower seal. The linkage is straight so I think the aftermarket part is a bit long and I don't think the sweep can be adjusted, can it?

Excelente

Very Good

Hi, I noticed that the driver's side wiper does not fully swipes the windshield, it leaves a gap on the left side. How do I fix that?

Still working??

I dont know why did you cut the video at the end, i think it tooks you along time to find the correct position that connect the metal piece with the motor..before you remove that piece you should have marked it in relation to the motor..What surprised me is the stupid dedign of the linkage and the motor connection

hi

I just replaced my wiper transmission and it's not working so good. I place them on the bottom of the windshield and then they go up and then stop in the middle of the windshield. when I push the button again they go down then up and then back to the middle. what could I have done wrong. please help!!!

it's just tinkering

try working on a freelander,you have to be more than a mechanic.

This is not a proper fix, should of replaced the bushing. I would do it this way only if all other options are not possible.

hey mate! are you by any chance afraid that someone might hear u speaks or speaking alone? haha looks like you're doing this video while playing Hide and Seek!,.