How To Install ZZP Stainless Cat Back! Before and After!

Рет қаралды 2,163

Жыл бұрын

Here is a how to video on installing ZZPERFORMANCE 2.5 inch Cat Back Exhaust System (no mufflers). I will also let you hear the before and after! In my opinion I think they are worth the buy! They give you a quality yet deeper and smoother sound!
Buy them here!
zzperformance.com/collections...
Support me on my Patreon:
patreon.com/The3800Daily

Пікірлер: 34

@ethanvink1710 Жыл бұрын

Great in-depth tutorial! If you haven't done a downpipe yet, get the equalizer!!! It is pricey, but TOTALLY worth it. My Bonneville sounds smooth and crisp, almost like a 2j or other i6s!

@The3800Daily Жыл бұрын

Thanks very much! My plan is to Twincharge. With the Z3 turbo kit comes the 3" down pipe so imma try and hold out till then

@captainamerica3531 Жыл бұрын

Sounds great

@arcentalesnoel Жыл бұрын

Excellent video!! It sounds much better! Nice!

@The3800Daily Жыл бұрын

Thank you very much!!! Down pipe soon I hope

@vetteguy6902 Жыл бұрын

Sounds much better.

@The3800Daily Жыл бұрын

Thank you!

@neonpeonu Жыл бұрын

Good video man!

@The3800Daily Жыл бұрын

Thanks a ton!!! I hope it helps!

@dogprowilhelm7630 9 ай бұрын

Don't use WD-40 on exhaust hangers, hydrocarbons dry rot rubber hangers. Use silicone gel Sil-Glyde good to 600 deg.

@The3800Daily 9 ай бұрын

Heck yeah! Thanks for that bit of advice! That's a real pro tip!

@STREETRACEN4U 8 ай бұрын

soapy water works good too

@danielanderson8502 Жыл бұрын

I JUST did this! I had a ZZP catless dp on it but removed it because it was 2.5 outlet. So I got the full 3” system with the ZZP muffler. The sound to me was meh but it is kinda growing on me. I was hoping on a Flowmaster tone. Good job on the video!!!!

@The3800Daily Жыл бұрын

Thank you!!! Yea I keep hearing people say it's too quiet with muffler's. Why catless if u don't mind me asking?

@danielanderson8502 Жыл бұрын

@@The3800Daily I had the catless dp laying around so I did that until the 3” exhaust came in. The catless dp is a full 3” but the exit is 2.5 ish. It would work on your car since you have a 2.5. But I had to rebuy a catted dp so I can have a full 3” exhaust.

@The3800Daily Жыл бұрын

@@danielanderson8502 What about on the power log side? Does it taper back down to the stock size?

@danielanderson8502 Жыл бұрын

@@The3800Daily yes. It is a full 3” from the power log until you get to the exit where it would bolt on to the exhaust. I also have the power logs and the new ZZP crossover pipe as well. It fit perfectly but since I have a Regal GS I wanted to run ZZP’s exhaust so I had to change the downpipe. This catless downpipe would totally work with your car!

@The3800Daily Жыл бұрын

@@danielanderson8502 well I think I will keep the cat but thanks!!! I just hate taking the down pipe off. It's so tight back there!

@elchapo9619 Жыл бұрын

Do you not have a zzp downpipe if not thats why your dyno # are low… i had a similar set up power logs crossover downpipe same intake. Catback and was making closer to 270 3.3 pully

@The3800Daily Жыл бұрын

Thanks for that! I didn't get one yet because I plan on twincharging. And the Z3 kit comes with a 3" downpipe

@elchapo9619 Жыл бұрын

@@The3800Daily oh sorry that make sense