How to make conveyor belt splicing

Рет қаралды 85,289

6 жыл бұрын

This video introduce the Fabric Conveyor Belt splicing procedure. The splicing including: 1,GENERAL PREPARATION; 2,Dimensions of Fabric Hot Splices;3,Step Lengths; 4,Preparation of the lower part of the belt;5,Preparation of the upper part of the belt;6,Dry Fit of Splice Ends;7,Joining of the splice;8,Vulcanizing the splice.
Our KZfaq / @proconveyorbelt7942
Our facebook / proconveyorb. .
Our Twitter / proconveyo. .
Our linkedin / probelt
Our Web www.pro-cb.com
Our E-mail:pcb@pro-cb.com

Пікірлер: 14

@hejatexgmbh4753 3 жыл бұрын

This is an excellent explanation with traditional hot splicing material. If you want to reduce the processing time after all preparation, I recommend to try the new generation of vulcanizing material Multiface. As it is already liquid and achieves the sulfur crosslink at ambient temperature you need only 80 degrees Celsius and 2-3 bars pressure and less time to finalize the job.

@Panchamoorthy84 3 жыл бұрын

Super

@epnuoepnuoconveyorbeltvulc9677 3 жыл бұрын

👍

@ronstevens5884 5 жыл бұрын

Get that razor knife away from that belt.Where's your belt knife man?lol good job and thanks for the video

@chaddixon5725 4 жыл бұрын

Never seen that.

@HuangXingQing 5 жыл бұрын

Han hao!

@calebhisle624 Жыл бұрын

Why do they pull the steps like that an not at a angle get it all in one go

@pmabhilash85 4 жыл бұрын

As a conveyor belt vulcanizer with 15 years experience; your splicing is taking too much time.how may times you are removing plies. We normally taking only three times if 4 ply. And also not giving bias for splice.

@wilsonvillapando9112 3 жыл бұрын

Conveyor belt technician almosh 10 years

@CaptnFox 5 жыл бұрын

i work as a conveyor belt technician and have worked with belt splicing for almost 10 years and i'm sorry but i this must be the most ridiculous technique i have ever seen (sorry for being blunt).....and a splice that i 90 degrees or close to that is just stupid! you risk to much tension on the splice every time the splice is passing the turning point of the conveyor. room for improvement.

@proconveyorbelt7942 5 жыл бұрын

you did not watch carefully. The splice angle is not 90°. You mentioned is common knowledge for every one.