Trying to make a dreaded task a bit easier for you. This is how we do our alignment and we hope it helps simplify the process for you. While the video is long, this really only takes us about 10 mins or less.
Пікірлер: 20
@kylewheeler116111 ай бұрын
ABSOLUTELY SPOT ON (PUN INTENDED)!! Excellent tutorial and a must for anyone having mirror alignment issues like myself. I don't know how you could have made it any better! Hats off to you and you're an asset to the laser world for sure!
@HouseOfLasers11 ай бұрын
Thank you
@davehastings92453 жыл бұрын
OMG!! Where was this video when I was trying to figure out how to align my laser? LOL It took over a week, several hours a day, multiple you tube videos, and a lot of of swearing to finally get it thru my old head! Wow this has to be the BEST video on laser alignment out there to date. Kudos to you sir, very well done! I will recommend this video to anyone/everyone having problems aligning their laser.
@HouseOfLasers3 жыл бұрын
And this is why we do what we do Thank you!!
Жыл бұрын
Thanks!
@mysteryck133 жыл бұрын
Excellent. Thank you Chris and great job!
@HouseOfLasers3 жыл бұрын
My pleasure!
@GaryGraham663 жыл бұрын
Slightly off centre is better than dead centre, this allows you to rotate the mirror if it gets burnt. The main thing is that it hits the same spot on mirror 3 all over your bed. I wish I had a red dot on my laser lol a damn sight easier.
@Taran-d.B.232 жыл бұрын
This Combining Lense Setup for the visual Laser is great 👍🏼 can i buy it somewere seperare? Because my Visual Laser is just screwed to the nozzle and not alines with the true laser. Thanks
@gpentsas3 жыл бұрын
Hello and thanks for the very informative video. I understand that the combining lens with its holder and assembly comes with the specific laser machine? Any ideas where I could source such a combining lens for a DIY assembly? Thanks
@ericlandrum24363 жыл бұрын
great video I'm in full study mode until my thunder laser arrives!!
@karvtek3 жыл бұрын
Great video. Thank you. Have you tried the reverse alignment tool from AP?
@whynotcnc88283 жыл бұрын
thanks
@saint_tuna3 жыл бұрын
Hey there. Thanks for the helpful tutorial! Trying to get my laser aligned. I aligned the red dot and beam perfectly to mirror 2. When I pulse the beam to the third mirror, the laser pointer is center but the beam fires about 2 mm higher than the pointer. How can I correct that?
@HouseOfLasers11 ай бұрын
you have to move your pointer typically. this is not a one mirror adjustment.. you have to fine tune along the way
@quochaonguyen17323 жыл бұрын
How to maintain the belt?
@bgauweiler2 жыл бұрын
Has anyone seen an aftermarket upgrade that would allow you to add the red pointer as shown in this video to a "Chinese" 100W laser?
@HouseOfLasers2 жыл бұрын
You’ll need the pointer and combiner lens I think they make a kit. Check cloudray you may have to change out mirror 1 and it’s holder
@monavieforal3 жыл бұрын
Good job. But not everyone has a red dot pointer. Be nice to have a video without the red dot.