Ty for continuing education on board. Mabuhay mga ETO
@efnd7436 Жыл бұрын
My friend. How about the Ampere reading during test on load. How much the value to make the battery is good condition. Tks for reply
@marvinho-9392 Жыл бұрын
nice lek
@leckylouie Жыл бұрын
Thank you
@vaishakhsailor3956 Жыл бұрын
Is that the way.. ??I saw different method by connecting bulb in series connection and put the battery on load and note down the ampere and voltage every hour for 10 hours minimum
@gbacon4551 Жыл бұрын
I've noticed you did not shut off the charger of gmdss battery while performing the performance test, meaning it continuously charging, maybe you need to switch if off in order to maximize the full power within 24 hours for how how the battery can power independently.
@leckylouie Жыл бұрын
Thank you for your comment sir. When I switched off the supply breaker, that is the power source of the battery charger. It has also alarm that the battery is in use. During power failure, it will automatically change over to back up battery and the LED "in use" will activate . 😁
@leckylouie Жыл бұрын
If the battery charger is in service, the voltage reading is about 27volts because the charger output is 27VDC.
@marksteventv47479 ай бұрын
sir ano yung reading s before and after sa amphire?
@axxtv9282 Жыл бұрын
Moniminitor din pla yan sir ngaun ko lang din alam
@leckylouie Жыл бұрын
Yes po sir. Basta part of safety at emergency power ay kailangan ng routine inspection.