How to pull engine fault codes on a bus without a diagnostic computer.

Рет қаралды 8,330

2 жыл бұрын

#busministry # busmaintenance # keepthebusesrolling
Church Bus or School Bus Maintenance Tip
This video shows how you can get the engine fault codes on a bus without having to have a computer to read the codes.
The bus shown is the 7.3L T444E Engine - International - this works on 1995 - 2005
Here is the link to see what your flash codes stand for.
www.truck-manuals.net/interna...

Пікірлер: 9

@parkerfamily9447 24 күн бұрын

Thank you. This was super helpful!!

@0312Productions 2 жыл бұрын

Thank you so much for this!! I own a bus like this and I’m sure this will help a great deal in the future!

@KidsMinistryTools 2 жыл бұрын

Glad it was helpful!

@davidfountain1165 Жыл бұрын

thank you so much!!!! very much appreciated!

@KidsMinistryTools Жыл бұрын

You're welcome!

@AliciaAlawine 17 күн бұрын

Thank u!

@Michaelajacksonfilms 5 ай бұрын

Thank you

@alexkalsatos5555 Жыл бұрын

Thanks Josh now I can check the codes on my bus after seen your video. My bus is a 2004 int 3800 444e 7.3L for the last 3 years at times would only click by the driver side behind the switches after a few attempts or hold the ignition for 5 seconds would fire up, now it only clicks no crank, I jumped the starter and solenoid it cranks no start, I run a direct wire from the selonoid to the switch it cranks but no start. I also don't have stop lights and the booster motor is no sound when I apply the brake. When I connect power to the brake booster is alive. Any suggestions to make it work is highly appreciated.

@MEMO-vb4xr Жыл бұрын

Hey, Josh at work we have a 2007 International School Bus the Transmisson Check Light is on. The transmission does not activate 5th gear in motion. However, fith gear goes in when the MODE is activate. Any recommendations or souces. Thanks