This was such a great video! I need to know how to install a door. Well they're be a part 2??? 🙏

Your video really helped me with replacing a whole door and frame for the first time

I was looking for the part 2 of actually installing the door frame.. He makes it look easy besides destroying everything.. I have no experience and i need to remove all my bedroom doors, bathroom doors, and closet doors and install them too..

Thought that recip saw looked neat until you tried to use it.

There are countless vids on how to remove the trim on YT, but none for the entire frame. As such, thank you very much for the demonstration!!

I was looking for part 2 video!

Great video. Needing to do this on 3 interior doors👍

Thanks so much! Exactly what I was looking for!!

If only my trim came out that easy! My house was built in 1924 and it's definitely hard to work on.

“I’m going to show you how to do this so you don’t damage any trim” ....proceeds to destroy everything

Very illustrative video! Sorry if this question sounds silly but I'm just wondering if could be any issue when removing the old door lining.. structural wise, collapse..? Thanks, Juan

Did you do another video showing how to fit a new one? Thank you.

I needed this. My bathroom frame has water damage from the toilet Bursting and wont close the door anymore 😅

Im doing some bathroom work. My bathroom is attached to my main room. In order to increase space on both sides, I am going with a barn door. I wanted to know after I remove the door and door frame. What should I do next to make it look like a normal walkway? Im a beginner and this is a small project for this spring.

Umm... ahhh.... ahhh... ummm.... Greatest advice ever given.

use a step stool, and take your time, you'll preserve more trim, the top piece went bad because you had to reach, the other side went bad, because you got frustrated,

Thanks so much for sharing your knowledge...Great video

Ahhh...the sawsall!! of course! Thanks!

Is there are a non-destructive way of doing this? I have a 100 year old home that I'm trying to restore while keeping as much of the original materials intact as I can. One of its problems is that there's not a single door in the entire house which is still square. I've already shimmed/bent the hinges back into place but - in many cases - the whole frame has gotten out of alignment.

Thank you, that was exactly the information I’ve been needing.

Not bad Joseph, -But please, cut down on the ums and awes a bit. ( shortens up the vid for us) -No need to saw back and forth when using your Sawzall. It does that for ya Joe. 😉 oh yea, get a new metal cutting blade Joe. - No need to see every nail banged in or make us wait while you do both sides. -Safety glasses are not only cool, but they're smart to use. Thank Joe. - -

That was so cool u made that look way too easy.

I cant believe you just did that in 8 minutes. Wish me luck!

Thanks for this. Video is 5 years old but did you ever record how to install the frame/trim?

Thank you for the thorough video.

At what point was it the...”This dam thing won’t do what I want and I need to destroy everything.”

I do like your videos, however maybe a good idea to protect yourself with mask, eyewear and protect the customer's floor as well. Mold could be present, in all that flying off wood. Just my suggestion. Thanks for videos.

Looks like part 2 never came :( But very helpful for removal!

Do you need a sawzall, or can you just pry out the frame?

Great video! Very well done, sir!

Great video! Thank you for posting this! God bless!

I can understand if you were cutting through screws. But I don’t get why you have to cut through the nails when pulling the door jamb off will pull them out with it?

Italians:just a screwdriver and a little bit of force

I'm no door installation expert but I think a cut off wheel on a grinder or a pneumatic one would work better than that sawzall

Nice safety glasses.. who makes them??

Do you have a install video too?

I had to that for my desk to fit into my office room. We used a crow bar and boy did it really mess things up.

Is it possible to remove the jamb by taking the trim off only one side?

I always use corded sawzalls, the battery operated ones aint it

He forgot to scream "snakes on the ground" after throwing that trim off into that room......is that correct protocall? lol

Sooooooo what happened to that stay tuned install video?

Great video. Do you score both sides

Thanks for the video. I thought that you said something about using pine casing rather than composite. It was difficult to hear so I am not sure. Can you say more about that? I am planning on installing new doors in my house and I am faced with this decision soon.

Somebody buy this guy a new Sawzall

Good video. Eye protection.

I don't think I'd hire this guy

Good video, just missing safety glasses 😬😬😬

Is this the same process to replace my frame and door in my backyard access on the house ?

Thank you for this video.

Great video. Thank you

Couldn't fit the new door after that?

Any video on how to install a door frame?

Sounds like Simon & Garfunkle Bridge over Troubled Water with all that echo.....Jeez

Fast removed in the door frame

Thanks exactly to the dam 👉 point💯💯

is the process the same for homes with plaster walls (no lathe)

Any chance of doing Part 3, installing a door?

Good info. So what if he got rid if the frame..needed to know how to do it.

thanks , me too!

Thank you.

My wall is concrete. Can this method work?

Did you ever install replacement for this

Not wearing safety glasses? Doesn’t matter how long you have done this. Safety first folks.

An Older Dwelling.

Heck naw I will pay someone to do it . I was all for it till he got that cutting machine.

your going to saw nails without eye protection right in front of my OSHA hand book!?

Nice video

12v is clearly not doing such a good job.. But good video though thanks.

You brought the wrong tool, that's a SawsSome not a SawsAll 😂

New Sub here. I’m four years late but I made it. 😅

It would help if you used a REAL sawzall

What brand of saw are you using

2:24 "It just pops right off..."

Can’t believe I use sleep with this guy , until this day his wife doesn’t know

Thx

I was just going to ask about safety glasses too! Scary to watch!

Based on this video, I can do this project.

Thanks husband is going to flip frame/door so this should speed up the process🎚🇺🇸💰💪😎

What happened to the install vid😮😮😮

lovely doggie

I've got an interior door with a steel frame. I've removed all the trim but can't figure out what to do next. There are no obvious screws or nails holding it in. Any suggestions?

The install??

Where is part 2??????

No safety glasses

Damn rough enough??

Hell nah that’s not how you do it and he knows it 🤣

Not good for UK.. They putting nails in size of Jezus crucifixion 😂😂

Wait, can I not do this without a saw??

Could you come do mines lol

Why is he speaking to the floor?

And a ladder

That escalated quickly :D

What about a 70 year old house? I don't think It will go that easy💩👍

Your video. Is manufactured

safety glasses for starters really guy

where's your safety glasses?

Thank you.