In this video I’m going to give you a very brief demonstration on repairing aluminum evaporator coils and copper to aluminum joints
Пікірлер: 18
@carlmccoy662Ай бұрын
Hope you get a million views
@peytonthompson2945 Жыл бұрын
Good demonstration! My experience with doing aluminum always turned out awful. The biggest difference I see is you are using a propane torch as opposed to an oxy acetylene rig os heat is more manageable.
@0komanji0 Жыл бұрын
Thank you. Yes I believe that the MAP gas is key for those that are not used to making these repairs.
@coolcool4833Ай бұрын
Rig OS heat = ?
@SomeGuyInSandy6 ай бұрын
Nice video!
@SomeGuyInSandy6 ай бұрын
You will begin to see a red "corona" in the flame as the aluminum comes up to temperature. You see red in your flame, dip the solder!
@kerrymenor30902 ай бұрын
Nice one man
@carlsmith5919Ай бұрын
He left a big hold on the copper to aluminum. That is not flux .
@keepthinking2666 Жыл бұрын
It might have been easier to use the multitude to get a clean-cut for the repair. Less damage to the fins
@2bnax2 ай бұрын
WHAT'S A MULTITUDE???
@2bnax2 ай бұрын
GREAT JOB!!! WHERE CAN I GET TORCH HEAD LIKE YOURS??
@0komanji02 ай бұрын
Home Depot or any hardware store
@2bnax2 ай бұрын
@@0komanji0 THANK YOU VERY MUCH!!!
@LEONDELASIERRA1 Жыл бұрын
Hi can you give me the full name of this brazing rods?
@0komanji0 Жыл бұрын
Harris is the manufacturer. I'm using the Aluxcor 78/22 rod.
@LEONDELASIERRA1 Жыл бұрын
@@0komanji0 Thank you for being so kind..
@jorgeposadas1192 Жыл бұрын
No, at what time did you say to use flux?
@0komanji0 Жыл бұрын
The solder I use in this video has a flux core. You don't need additional flux.