Рет қаралды 9,955
Buy Now!
New Blower Motor Resistor from 1AAuto.com 1aau.to/ie/1AHBR00028
This video shows you how to install a new TRQ blower motor resistor yourself in your 1993-1997 Ford Ranger. The heat and air condition fan is controlled by a separate module, called the blower motor resistor. The nature of this component’s job causes it to heat up frequently, which can lead to failure. If your vents will only blow one speed, this is likely the cause. TRQ has a new resistor module made specifically for your vehicle.
This process should be similar on the following vehicles:
1993 Ford Ranger
1994 Ford Ranger
1995 Ford Ranger
1996 Ford Ranger
1997 Ford Ranger
Tools you will need:
• 5/16 Inch Socket
• Ratchet 1aau.to/oEP/1AXAA00016
• Pick 1aau.to/of7/1AXAA00037
Subscribe: / @trq
Check out our playlist:
Ford Ranger 2nd Generation 1993-1997: • Ford Ranger 2nd Genera...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.