Рет қаралды 508
Buy Now!
New Control Arm with Ball Joint from 1AAuto.com 1aau.to/ib/1ASFU00007
This video shows you how to install a new front upper control arms with ball joint from TRQ on your 1994-1997 Honda Accord. Control arms are a crucial part of the suspension system of your vehicle. They not only carry the load of the vehicle to the wheel, but they typically also maintain its alignment. Control arms are typically large and strong, so you may be surprised it needs replacing. They contain rubber bushings for smoother rides at the cost of eventual wear, or integrated ball joints that require replacing the entire arm when they wear.
Estimated installation time for a professional technician is approximately: 2 hours 0 minutes
This repair was done on a 1995 Honda Accord LX 2.2L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
1994 Honda Accord
1995 Honda Accord
1996 Honda Accord
1997 Honda Accord
Tools you will need:
• 15mm Socket 1aau.to/ocen/1AXAA00015
• 18mm Socket
• 19mm Socket
• Torque Wrench 1aau.to/obhI/1AXAA00044
• Bungee Cord
• Gloves 1aau.to/obhu/1AXSS00048
• Liquid Thread Locker
• Safety Glasses
• Floor Jack 1aau.to/oaCm/1AXAA00068
• Hammer
• Jack Stands 1aau.to/oao3/1AXAA00065
• Wheel Chocks
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.