Рет қаралды 596
Buy Now!
New Idler Arm from 1AAuto.com 1aau.to/ia/1ASIA00043
This video shows you how to install a new idler arm from TRQ on your 2007-2014 Chevrolet Silverado 2500 HD. If your steering is feeling clunky, but you checked your tie rods and other outer components, consider the idler arm! This part that connects the steering shaft to the steering linkages can wear out and get loose or clunky too!
Estimated installation time for a professional technician is approximately: 1 hour 12 minutes
This repair was done on a 2011 Chevrolet Silverado 2500 HD LT 6.0L Crew Cab Pickup 4-Door 4WD Automatic and the process should be similar on the following vehicles:
2007 Chevrolet Silverado 2500 HD
2008 Chevrolet Silverado 2500 HD
2009 Chevrolet Silverado 2500 HD
2010 Chevrolet Silverado 2500 HD
2011 Chevrolet Silverado 2500 HD
2012 Chevrolet Silverado 2500 HD
2013 Chevrolet Silverado 2500 HD
2014 Chevrolet Silverado 2500 HD
Tools you will need:
• Pry Bar 1aau.to/oaar/1AXAA00020
• 15mm Socket 1aau.to/ocbw/1AXAA00015
• 18mm Socket
• 24mm Socket
• 30mm Socket
• 1/2 Inch Impact Gun 1aau.to/oy3/1AXAA00252
• 3/8 Inch Impact Gun
• 1/2 Inch Breaker Bar 1aau.to/or5/1AXAA00078
• Socket Extensions 1aau.to/ocbw/1AXAA00015
• Swivel
• Gloves 1aau.to/obcd/1AXSS00048
• Safety Glasses
• Rubber Mallet
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.