How to replace Passanger side axle on 2008 Honda Accord

Рет қаралды 36,488

4 жыл бұрын

Due to factors beyond the control of RB The Mechanic, it cannot guarantee against unauthorized modifications of this information. RB The Mechanic assumes no liability for property damages or injury incurred as a result of any of the information contained in this video. RB The Mechanic recommends to follow safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of RB The Mechanic, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not RB The Mechanic
Buy the axles for 2008 Honda accord on Amazon amzn.to/2na10Hc

Пікірлер: 79

@drivewaybuilds Жыл бұрын

You helped mug better than A1 auto video

@RBTheMechanic Жыл бұрын

Thank u!!

@johnt890 4 жыл бұрын

Great video. Thank you for taking the time to make this.

@MrSupernova111 2 жыл бұрын

Damn bro! How did I miss this video! I have the same vehicle and when I went to replace my bearings recently it was a massive pain removing the axle from the hub. Essentially, I had to soak it in PB Blaster and let it sit overnight. Even then, it took a lot of effort to remove it the next day. The axle was practically seized in there. I haven't had to replace the axle itself yet but I won't be surprised if the day comes as its an old vehicle. Thanks for another great video! Cheers!

@RBTheMechanic 2 жыл бұрын

Yeah some axles get stuck I had few where I had to replace spindle and bearing I had to pull out axle and full spindle togather and throw it out

@MrSupernova111 2 жыл бұрын

@@RBTheMechanic . That sucks! I'm glad that I was able to take my time and finally get it out. Cheers!

@tstut111 2 жыл бұрын

awesome vid! i messed up big time because i mixed my little guy up with my other little guy,.car rolled right into the garage door.

@johnpaulgarrett1 2 жыл бұрын

Great job, thanks.

@HRS8509 11 ай бұрын

nice work!

@RBTheMechanic 11 ай бұрын

Thank you! Cheers!

@j.v.1166 3 жыл бұрын

I did all that work on both sides and other suspension work on my 08 but after a month or so, the passenger side axlehas slid out about a half inch and I was told by my alignment shop that all I had to do was hit it with a mallet on end of axle to slide it back in and to make sure it clicks in. I'm not sure how it managed to slip out but my guess is that since it was my first time doing this job I must've not installed it all the way in.😓.if I hit hard enough can I damage the transmission threads where it grabs on?

@RBTheMechanic 3 жыл бұрын

No I cannot damage I have to align the axle with the groves then hit it with mallee it will click on u can feel it go click u can’t hit it too hard try it again

@cristianramirez4298 4 жыл бұрын

The axle is connected to the axle shaft? I’m trying to do the same thing but I don’t know how to get the axle out. Like am I suppose to take the whole thing out from the transmission? Or it could be disconnected from the shaft?

@RBTheMechanic 4 жыл бұрын

cristian ramirez remove the whole thing it popped out from the transmission use pry bar

@nonamovsesyan2868 2 жыл бұрын

I changed both axel on my honda accord 2008 after changing the cv axle the lights came on the dash vsa ABS AND TRIANGLE LIGHT ON WHAT CAN IT BE PLEASE HELP.

@RBTheMechanic 2 жыл бұрын

Scan the car maybe u damaged the abs sensors scan for codes

@youngsumma 3 жыл бұрын

I need to replace my intermediate shaft too. Can you do a video on how to bod that plz?

@lcameeno1 3 жыл бұрын

Comes together

@SAMUELTHESIXTH 2 жыл бұрын

Replaced the driver side axle. the inside part of the axle extended when I put the axle back through the hub. Is that normal?? Looks like it happend to you in the video as well. Just wanted to make sure before I drive it tomorrow. Thanks!

@MrSupernova111 2 жыл бұрын

Apparently, the internal parts in the boot can come loose. What did you find out in your case?

@willambell1891 2 жыл бұрын

Hey. I have a question. On my 03 Honda Accord 3.0, my passenger axles had a bracket with three bolts on it that is either bolted to the motor. I have never seen any video of a Accord with that bracket. Have you ever came accors it??? I'm having trouble removing it and no one seems to know what bracket I'm talking about

@RBTheMechanic 2 жыл бұрын

Ur talking about the intermediat shaft it got blacker with bearing in it all the v6 has that that’s the other half axle comes out of that

@willambell1891 2 жыл бұрын

@@RBTheMechanic oh okay. So when I'm changing the passenger side axle Its different from the driver's side? I DNT need to remove that bracket or that rod that goes in the trans, I jus slide the axle off and it comes out of that rod and I slide the new one in? I DNT mean to sound dumb or nothing, but my new axles has the whole piece, it even came with ty he bracket

@RBTheMechanic 2 жыл бұрын

@@willambell1891 yeah here’s another video I took out that shaft u can forward the video about 12 minutes u will see me take off the middle shaft kzfaq.info/get/bejne/fLuToZmdnKnVdJs.html

@RBTheMechanic 2 жыл бұрын

@@willambell1891 not sure but u wanna post up small video Leme see what u got

@packerman1203 Жыл бұрын

Knocking out the axle from the inside there at 11:01 is way harder on the v6 with the exhaust being right there below it, my 2010 crosstour has rusty hardware on the flex pipe so i have to cut it out just to get at this and the last bolt holding in the transfer case, and then i can rip the engine out, thanks timing belts for not working immediately at 100k

@RBTheMechanic Жыл бұрын

It’s actually easier it short axle I have video on Acura MDX which is similar

@garytaylor8162 3 жыл бұрын

RB, my wife's 2012 Honda Crosstour has a vibration at startup/acceleration (like an slight unbalanced tire, BUT only feel it in the seat (butt). No steering wheel shake. Turning wheels left and right, extreme circling slowing does NOT make any cracking, popping, or clicking sounds. Tires were rotated and balanced (no help). After up to 35 mph, then smooth sailing with no detectable vibration. How can I rule out the CV axles? Nothing obvious from boots like tears, leaks, etc. Thanks again, friend!

@RBTheMechanic 3 жыл бұрын

Gary Taylor first thing u have to try is rebalance the tires

@jorgehetnandez1696 3 жыл бұрын

Gary Taylor i have the same issue with my Honda Accord. Did you find out what the problem is? My friend tells me it might be the left CV axle. Not the driver side but the passenger side.

@RBTheMechanic 3 жыл бұрын

@@jorgehetnandez1696 best thing is knock them out both

@jorgehetnandez1696 3 жыл бұрын

RB The Mechanic i took your advice and i did replace both CV Axles. Thanks. I feel better now. 😊

@RBTheMechanic 3 жыл бұрын

@@jorgehetnandez1696 cool nice job! Best way to do it every time I changed one axle customer complained noise because noise was hidden lower noise

@julianarodriguez3635 3 жыл бұрын

Do you have to get a wheel alignment

@RBTheMechanic 3 жыл бұрын

That would be good idea

@jasonmefford4312 4 жыл бұрын

I found it much easier removing the lower a-arm bolt and leave the tie rod and strut base on. IMO

@RBTheMechanic 4 жыл бұрын

Jason Mefford you can do it that way also

@CMDBoy Жыл бұрын

I have 2011 Honda Accord ex l I just put the passenger side axle I drove it to my job and the axle came off place idk if I put it rite

@RBTheMechanic Жыл бұрын

Either axle is wrong or it didn’t snap in properly

@CMDBoy Жыл бұрын

@@RBTheMechanic ok kool ima check it again today wen I get off work wen I’m done ima send you a video to see if I did it rite thanks 🙏🏼

@williamvieau5259 4 жыл бұрын

Great job but removing the fork from the strut is not necessary just heads up don’t do more work then you need

@jlentz17 3 жыл бұрын

Right?? Pretty sure he’s trying to charge more for labor.. it’s supposed to take like 10-20 min :/

@josemuralles226 3 жыл бұрын

Just did mine yesterday all I took out was lower control arm nut and one the the bolts for the strut

@jlentz17 3 жыл бұрын

@@josemuralles226 exactly! It’s so much easier than he says. I did mine in my Scion iQ and realized it was my strut mount but it was a lot of fun hahah

@MrSupernova111 2 жыл бұрын

That's what I thought too. Thanks!

@Only1Jfinesse 2 жыл бұрын

What kind of cotter pin?

@RBTheMechanic 2 жыл бұрын

Might have to find the size at part store there is no type

@Nate20 2 жыл бұрын

How much for this labor wise

@RBTheMechanic 2 жыл бұрын

$90

@nvirmusian5318 2 жыл бұрын

Hello sir can you help me i took my car to fix the cv axel on a 2008 honda accord after he fix he told me to drive a bit the light are on the dash vsa abs and triangle light on help

@RBTheMechanic 2 жыл бұрын

He broken the abs sensors sensors

@nvirmusian5318 2 жыл бұрын

Yes it was the sensor finally done i told my mechanic to change it and he did change it for free 😃

@nvirmusian5318 2 жыл бұрын

Thanks

@RBTheMechanic 2 жыл бұрын

@@nvirmusian5318 welcome defiantly go back and let them know

@RBTheMechanic 2 жыл бұрын

@@nvirmusian5318 oh cool nice job!!!! That’s why I explain big time to loosen up the sensor so it don’t get damaged but nice u got it fixed!!!

@waynenewlun4027 3 жыл бұрын

Why do my axle popping out of my 2004 Honda Accord 3.0 automatic

@RBTheMechanic 3 жыл бұрын

Try another brand axle it can be few thing. Wrong axle. That has happned to me wrong axle popped out then it can be the axle was never put in all the way

@N2BURNIN Жыл бұрын

13:00-13:13, you took 13 seconds, me 2 hrs...

@RBTheMechanic Жыл бұрын

Sorry bro some times things r like that one time I spend 2 hours taking out axle from transmission and 10 seconds to put in new axle

@N2BURNIN Жыл бұрын

@@RBTheMechanic I read my service manual; I had too much grease on splines causing an air pocket. Also, if "C" clip has open end on bottom, it's much easier. TY for the upload!