How to Replace Power Window Regulator 2002-2005 Ford Explorer

Рет қаралды 27,984

2 жыл бұрын

Shop for New Auto Parts at 1AAuto.com 1aau.to/c/16/dL/window-regulator
Most power window problems can be traced back to either the regulator or the motor that drives it. TRQ produces affordable window regulators and motors that are designed specifically to fit your vehicle! This video shows you how to replace both the window regulator on your 2002-2005 Ford Explorer.
This process should be similar on the following vehicles:
2002 Ford Explorer
2003 Ford Explorer
2004 Ford Explorer
2005 Ford Explorer
Tools you will need:
• Pocket Screwdriver
• 10mm Socket 1aau.to/oLy/1AXAA00017
• 11mm Socket 1aau.to/oSQ/1AXAA00015
• 5.5mm socket
• Cutoff Wheel 1aau.to/ow/1AXAA00254
• Trim Tool Set 1aau.to/org/1AXXX00006
• T30 Bit 1aau.to/ojW/1AXAA00008
• Ratchet 1aau.to/oWX/1AXAA00016
• Drill
• Drill Bit Set 1aau.to/ow/1AXAA00141
• Painter's Tape
• Center Punch 1aau.to/odc/1AXAA00055
• Hammer 1aau.to/ooE/1AXAA00091
• Pick 1aau.to/okm/1AXAA00037
Subscribe: / @trq
Check out our playlist:
Ford Explorer 2002-2005 3rd Generation: • Ford Explorer 2002-200...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 26

@TRQ 2 жыл бұрын

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

@scottf136 Жыл бұрын

Best video I have seen. Would love another illustrating the back passenger door. On my 2003 Ford Explorer XLT, there is no 5.5mm bolt. The bolts holding the door panel are 7mm. Just as a reference, the dealer quoted me almost $800, parts and labor for both the driver's side front and back seat windows. I purchased regulators with motors for both windows for $205.

@rstevens1836 Жыл бұрын

I've just replaced my explorers window regulator, thanks to you. Great presentation of your video and your narration and explanations. Thank you thank you thank you!

@Beachbumkimmer 11 ай бұрын

You made an amazing video! Very knowledgeable and easy to follow. I love your narration. Very easy to understand and easy to follow instructions. I am a 70 year old G'ma who just bought a 2003 Expedition to haul my teen grand kids around in. Wish me luck! But I feel very comfortable trying to accomplish this task. Thanks again!!

@ronhat-nx6yq 11 ай бұрын

DO NOT remove the switch panel as is shown here because you will break the rear tab. First move the panel slightly away from the door, then pry the FRONT of the switch panel up and then slide it forward. As you will notice in this video, he has indeed broken off the rear tab.

@brucebreisch5593 11 ай бұрын

Outstanding demo. Without that video, changing the window regulator would have been very hard. I used my die grinder to remove the two rivets. Thanks.

@TRQ 11 ай бұрын

+Bruce Breisch Thanks for watching our video! 1aau.to/m/Shop-TRQ

@Amarillobymorning777 8 ай бұрын

Thanks buddy. My 02 Ford explorer got 193000 thousand miles. Two rear window motor and the driver side don’t work. used JB weld and leave them up ⬆️ for good . A/C blows cold air and got heater. we don’t go to drive through facilities with it . I got little joe Cartwright for it, my red C5 targa top. GR8 video clip 🙏

@chaunceysmith183 8 ай бұрын

What size bolt and nut did you use to screw the window back in???

@ronmellema1489 Жыл бұрын

My entire job went EXACTLY as you described. Great video.

@taylerknight3595 Жыл бұрын

Such a thorough video. Thank you for every detail!❤

@garydavenport3741 Жыл бұрын

Very thorough and to-the-point thank you

@6421rich 8 ай бұрын

I watched a few videos on thus and yours was by far the best with rhe detailed description and excellent camera work

@sirmoshalot8665 8 ай бұрын

Thank you sooo much!!! Was able to do this myself with minimal struggle. I would add to anybody taking this on themselves, the window regulator that I got to replace the broken one didn’t come with the hardware. The OEM regulator had those welded rivets and would need to be replaced. I got some that worked for about 10 bucks 😁

@TRQ 8 ай бұрын

+Sir MoshAlot Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-TRQ

@mikel1024 Жыл бұрын

On my 2003 explorer, the top regulator bolts had an interference problem with the window glass. I could not slide the regulator up into position to get the top bolts through the holes. Not enough space between window and door structure. Easily solved by pulling the window glass out. A five minute job.

@BeKind929 7 ай бұрын

Great video

@carlossilva3918 6 ай бұрын

Good video

@gs745li Жыл бұрын

Excellent

@c431inf 8 ай бұрын

Thanks dude 🤙

@texfx4405 5 ай бұрын

Great video!! I bought the part that is linked in this video, that was a mistake! Bolt holes did not line up and studs on the top of the regulator were too long. So I had to drill new holes and cut the top two studs. By far the worst aftermarket part fitting I have ever seen!!! Buy a different brand and follow this video.