Thanks so much for watching! I'm sure I will at some point, but if you want them right away you can go to our website www.2carpros.com and ask a question for absolutely free!

Thanks very nice video

I agree, he put them in from the wrong side and damaged the springs. That's why he had to you much force to get them in place. And I do recommend to use grease where the pads meet the bracket, else your brakes will jam quite soon and brake uneven. I also recommend put some grease in the bracket hole before putting in the caliber pins. That's because of the rubber boot that else will carve away all the grease before it enters the hole, which is seen in the video. Finally you must use red grease on the pin with the rubber ring. Petrol based grease will make this ring get swollen (even the rubber boots) and cause the break to not working properly. It is also very important to check the rubber boot so it seals the pin. The pin has a groove that the boot must connect behind, and then it is hold in place. Otherwise water will come in contact with the pin and cause rust. But nice video, great light settings, quality and close ups. I wish more videos had this kind of quality.

Was wondering about this too and thought I was doing it wrong. I go from the outside as well.