How to Replace Water Pump 1997-2006 Jeep Wrangler

Рет қаралды 13,298

8 ай бұрын

Buy Now!
New Engine Water Pump from 1AAuto.com 1aau.to/ib/1AEWP00046
This video shows you how to install a TRQ water pump in your 1997-2006 Jeep Wrangler. The water pump keeps coolant flowing through your engine. Common failures of the water pump will leave the coolant leaking, or stagnant. Both will lead to overheating if left untreated. Install a new engineered to fit water pump from TRQ for total peace of mind.
This process should be similar on the following vehicles:
1997 Jeep Wrangler
1998 Jeep Wrangler
1999 Jeep Wrangler
2000 Jeep Wrangler
2001 Jeep Wrangler
2002 Jeep Wrangler
2003 Jeep Wrangler
2004 Jeep Wrangler
2005 Jeep Wrangler
2006 Jeep Wrangler
Tools you will need:
• Flat Blade Screwdriver 1aau.to/obsp/1AXAA00013
• Pry Bar 1aau.to/oYk/1AXAA00020
• 13mm Wrench 1aau.to/o2H/1AXAA00010
• 10mm Socket 1aau.to/obmj/1AXAA00017
• 13mm Socket 1aau.to/obGM/1AXAA00015
• 14mm Socket 1aau.to/obGM/1AXAA00015
• 15mm Socket 1aau.to/obGM/1AXAA00015
• 17mm Socket 1aau.to/obGM/1AXAA00015
• 8mm Socket 1aau.to/obmj/1AXAA00017
• Coolant Funnel Set
• Vise-Grips
• Large Locking Pliers
• Locking Pliers 1aau.to/omS/1AXAA00139
• Pliers
• 1/2 Inch Socket 1aau.to/obJ6/1AXAA00016
• 1/4 Inch Ratchet 1aau.to/obmj/1AXAA00017
• Ratchet 1aau.to/obJ6/1AXAA00016
• Torque Wrench 1aau.to/oaPr/1AXAA00044
• Brake Parts Cleaner
• Cloth Rags 1aau.to/oFx/1AXSS00035
• Gloves 1aau.to/oaqQ/1AXSS00048
• Liquid Thread Locker
• Pipe Thread Sealer
• Safety Glasses
• Thread Sealing Tape
• Drain Pan
• Floor Jack 1aau.to/oadB/1AXAA00068
• Hammer
• Jack Stands 1aau.to/o2a/1AXAA00065
• Razor Blade / Gasket Scraper
• Wheel Chocks
• Wire Brush 1aau.to/ouw/1AXAA00079
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 13

@TRQ 8 ай бұрын

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

@DanielAlvarez-lo3fd 4 ай бұрын

This video gave me the confidence I need it to tackle this job. Just waiting on parts now. Thank you.

@kevinmacdougal8725 18 күн бұрын

This was very helpful, thank you for your time and expertise. One note, I replaced my Radiator at the same time as the water pump and Thermostat on my 2001 2.5L. Much bigger fan housing. Hint. If you separate the housing from the radiator and push it toward the engine over the fan, you can get to the 6 bolts that hold in the radiator in place. (auto transmission will have cooling lines going to the lower reservoir of the radiator that will need to be removed.) You can lift the radiator out and then remove the large fan housing. Before you loosen the the serpentine belt, You will have great access to remove the fan bolts and studs with resistance from the belt, so you don't need to do this on a table vice. :) Hope this helps.

@PonyRyd 2 ай бұрын

Just a heads up, on my 2006 Rubicon the fan actually screwed onto the water pump and I needed a Fan Clutch Holder tool to remove the fan and shroud.

@Olive-oilien 3 ай бұрын

Great tutorial

@jerryjeromehawkins1712 6 ай бұрын

Thanks Dude. Very thorough. 👍🏾🇺🇸

@lelandb387 2 ай бұрын

How did you miracle the fan clutch off? Either I mix something or mines completely different. This is the third different one I found. How many different ones are there all from 1997 to 2006?