make sure slurry still wet when screed goes on top...put screed in bucket or wheel borrow ready to go before speading slurry
@adelahussain46563 жыл бұрын
Very nice explanation thank you for sharing
@QLHTilingWaterproofing3 жыл бұрын
Youre welcome my friend
@joshkwd8527 Жыл бұрын
Thank you so much for your information sir much appreciated.
@QLHTilingWaterproofing Жыл бұрын
You most welcome thanks for tuning
@waikaato13 жыл бұрын
that was good bro im doing it round my pool surounds cheers
@jaydee95282 жыл бұрын
Great job guys
@musarezai62032 жыл бұрын
Very nice explanation thanks thanks
@QLHTilingWaterproofing2 жыл бұрын
You are welcome
@alihakimi12142 жыл бұрын
Good job done
@QLHTilingWaterproofing2 жыл бұрын
Thanks
@milesellis28473 жыл бұрын
Thankyou. This helped me a lot.
@QLHTilingWaterproofing3 жыл бұрын
Tiu U welcome
@alexanderchuyko48892 жыл бұрын
It`s a nice tutorial! Can you tell please how thin can be such screed layer? What kind of tiles is preferable for the flooring on top of it? Mosaic or large format 600*600mm porcelain? Does it need to be waterproofed under tiles? Thank you
@QLHTilingWaterproofing2 жыл бұрын
Hi Alex Thanks mate the thicker better if your screed is thinner the 20mm that will be a problem. You can lay any type of tiles but big tiles are preferred in bathroom or shower floor because it will be hard to give a fall to the drain or floor-west. Its better if you waterproof before you lay the screed but if the floor is rough yes you can waterproof on the screed as long as you use the correct methods.
@texazwhyte27912 жыл бұрын
Nice one fulla’s. What ratio of sand and cement for the screed, and how much cement and water for the slurry. Thanks for video!
@QLHTilingWaterproofing2 жыл бұрын
Hi Texaz No worries thanks for watching our videos. The ratio for sand and cement screed depend but in general 10 bags of 20 kilograms is used for 1 tone of sand which is equal to 1000 kilograms. So you need to mix one bag of cement for 100 kilograms of sand i hope that make sense to you. And for slurry 8kg cement to 15kg of water, if you want a stronger base you can add 2kg cement extra to make it more muddy.
@abdulqadirqaderi26233 жыл бұрын
عالی قیوم جان موفق باشی
@QLHTilingWaterproofing3 жыл бұрын
تشكور عبدال جان ❤️❤️
@hungnguyenquoc9487 Жыл бұрын
hi how thick do you need the screed to be to be strong enough? I am thinking 15mm? I don't want my shower to be much higher above the rest of the house which creates a large trip hazard. thanks
@RJ-je8nj Жыл бұрын
Once is finished do you use some primer before tile adhesive or you install tiles straight on bedding
@QLHTilingWaterproofing Жыл бұрын
Hi RJ No need primer straight on screed.
@benjamindelfs27186 ай бұрын
Yes you do? You need primer over every substrate surface. Where’d you learn to tile bro honestly
@deutschmithamid79523 жыл бұрын
لایک و مشترک شدی
@Mohammad73 жыл бұрын
well done
@geoffstein3896 Жыл бұрын
Hi mate, can I please ask what type of sand you suggest I use for the screed please? I will probably buy from Bunnings if they sell the type you recommend. Thank you
@QLHTilingWaterproofing Жыл бұрын
Use sydney sand but dont buy from bunnings it will cost you more buy from sand and soil place
@geoffstein3896 Жыл бұрын
@@QLHTilingWaterproofing thank you very much
@QLHTilingWaterproofing Жыл бұрын
You welcome
@1227babo Жыл бұрын
Good job, mate!! But use gloves to protect your hands. Cement is harmful to your skin.
@QLHTilingWaterproofing Жыл бұрын
Yes totally agree thanks for your comments
@donnastein49462 жыл бұрын
Thanks for sharing. What is the slurry for and is it dry before you screed over or still wet? Thanks
@QLHTilingWaterproofing2 жыл бұрын
Hi Donna Slurry is basically water and cement. And no it must be wet if its dry the screed wont stick.
@donnastein49462 жыл бұрын
@@QLHTilingWaterproofing So to help with bonding the screed to the slab of the house then
@vannguyen32519 ай бұрын
Thanks
@geoffstein3896 Жыл бұрын
Hi, how do you do your screed without a laser level? Hiw do you know what height you are going and where the high and low spots are? Thank you
@QLHTilingWaterproofing Жыл бұрын
Hey Geo We don’t use laser level you dont need to use. You need spirit levels only different size. Lets say if i am screeding bathroom 2m*3m and the drains are in the center, after screed is mixed and pouted in bathroom, then my start point will be from the primeter of the bathroom and shower. Step one, do your grid line around the primeter of bath & shower . Step 2, start your next gridline from the perimeter which will be high points and falls towards the drainage point lower point. I hope you understand but i will make another and explain all these things. Thanks 🙏
@geoffstein3896 Жыл бұрын
@@QLHTilingWaterproofing Thanks heaps for taking the time to reply, I really appreciate it. Any chance you could make KZfaq video on the steps please? I see you have a few videos but you seem to do it so quick there's no real explanation on the steps you go through. Thanks, and love your channel
@nathank5140 Жыл бұрын
Do you have to waterproof on top of the scree?
@QLHTilingWaterproofing Жыл бұрын
Hi Nathan Thanks for the question No don’t have to its just more and another layer of protection if you do.
@sayedafg82803 жыл бұрын
ماشاءالله قوما ء
@QLHTilingWaterproofing3 жыл бұрын
Thanks
@davidcollins22582 жыл бұрын
When is the waterproofing layer done? After the screed?
@QLHTilingWaterproofing2 жыл бұрын
Hi Mr David the waterproofing was done after screed.
@mead6754 Жыл бұрын
puddle flanges all all drains where missed, should be installed under the screed not on top
@QLHTilingWaterproofing Жыл бұрын
Hi mate yes waterproofer installed before screed gose on
@Jay-ParaOz Жыл бұрын
No waterproofing?
@denoravi68633 жыл бұрын
Lol get Screed mixer mate 😂😂
@QLHTilingWaterproofing3 жыл бұрын
Goday mate you dont need a screed mixer for one shower screed.
@contagious7775 Жыл бұрын
Agreed, more time to load and unload + cleaning.
@7colliemac Жыл бұрын
Also a mix that dry would stick to the mixer bowl.
@nelokitchen32573 жыл бұрын
👍👍👍👍👍👏👏👏💯💯😊
@QLHTilingWaterproofing3 жыл бұрын
❤️❤️❤️
@simonvsworld2 жыл бұрын
Don't you think you should have waterproofed the shower first?
@QLHTilingWaterproofing2 жыл бұрын
Hi Simon thanks for your comment. Its a good idea if you waterproof the floor first but You dont have to waterproof. If the floor is not level and even, not having enough falls towards the drain under the screed it its not a good idea to waterproof under the screed but if the base is nice and flat got falls towards floorwest or levelled must be waterproof before the screed.
@simonvsworld2 жыл бұрын
@@QLHTilingWaterproofing you should refer to the BCA
@sammy67703 жыл бұрын
Afghan way no need for a mixer.
@QLHTilingWaterproofing3 жыл бұрын
No need mixer for quarter of sand. We do use mixer for big jobs.