The focus dude!

Good info, but you gotta review your product prior to publishing... your focus made for the loss of what you're showing.

Personally I didn't watch this all the way. Interesting video. But the voice echo and background music together was off putting. You need a body mic.

Tip: I usually have my heat shrink already on there before connecting wires, especially if I’m going to have a long strip I won’t have to pull the shrink all the way to the solder job. Also, you can always put Heat shrink on your swan’s mouth, it will soften her teeth so she doesn’t damage your LED strip. Happy soldering, god bless my friends

Why do you want to solder them, being 100% serious I legit don't see the point when u just plug them in?

Can’t see ANYTHING your doing because of the focus!!

I can safely say your camera was out of focus

Bruh I don’t even have led lights

useful video, i suggest you, have a mic attached to you when u speak for clear audio, I also suggest you have your auto focus on the camera.

Just a quick thing I've found... soldering from the inside out is easier than across. If you solder the inside wires first (red and green), then you won't have to crossover the other wires to solder the other two.

Just found this video. Thanks for making it. After soldering a couple of strips, I used a small Popsicle stick under the strip. Using the alligator clip to clamp both the stick and the strip together really stabilized it. Now I can put some real pressure on wire and strip and it won’t move away.

Man, I have been struggling with soldering the led lights. Thank you for making this video.

I want to take the time to say thank you, i check a lot of video and yours was by far the most helpful to me. I order some angle connectors and the seller send me wrong one.. so i decided to do it myself by soldering wires... never practice since i was kid.. better to tell that i am really bad at it, after watching your video its helped me a lot. For protection i did not use what i think you called heat and shrink, i only use glue gun for make sure that it goes between solder, because they were so horrible that i scare it touch each other and malfunction.. ok i finish writing my book.. so just thank you for this video.

Your a life saver, my soldering is now sticking and not falling off lol, thanks for the video!!!

Straight to the point and no extra unneeded vobab. Thanks for confirming it is possible to do, brother man.

Thanks man, great advice on the technique. This made my project so much easier!

After wasting about 20 pixels and 5 connectors, this is the video I needed ^.^ Thanks for making it! Will report back after I try this technique.

Nice video. I like the way you did this. Super helpful vid bro. I'm going to try this technique today on an LED project I'm working on.

Really liked your video, I'm going to be trying to solder some led lights soon, so far most videos are full of useless info, yours seems to be to the point, never soldered anything before, I'll update after. Thanks again for the video.

Love your video just bought a Weller soldering station to do LED strip tape light I'm having a hard time with the four strips