I was overwhelmed at the prospect of troubleshooting a hoverboard that won't stop complaining about a low battery. Between this video and your website I think I can pull it off. I appreciate you making it easier

Thanks for sharing your knowledge

Where can we buy new batteries for hoverboard?

Hi, I had a hoverboard in which batteries are dead when I tried to open the BMS board 2 MOSFET RU6888R A or short I can't find similar can I replace any N channel MOSFET

You helped me a lot thanks

been a while and today I decided to ride my board but once I get on it goes off...the charger keepsblinking red/green ...what might the problem be??!batter or charger 🔌 ?please thanks

Thank you so much. I have looked for so long to find out the problem with my hover board and nothing helped at all. All other videos sucked and were unclear. I tested it with my multimeter and had the exact same readings as your faulty battery. Around 3.6. I’m about to buy a new one.

Thank you

How long do you need to charging the new battery after replacement or it gonna turn green after is fully charged

Any ideas why there is one(steady) consistent ringing?

I revived My hover board battery and the voltage on B- and B+ show 38volts but through the actual xt60 connector it reads 25volts. I’m guessing it’s a faulty bms but it was working before this happened.

Some battrries multimeter reading give 18-19 volts, its fine as this is the output of the internal controller board, if you opened the battry and probed the batteries directly, it will give you 36v

Tengo como 200 baterias de esas, donde puedo mandártelas..??

Hi! Just wondering what your location is. We have a swagtron that isn't working and want it to be repaired. Our swagtron won't turn on unless plugged in, and when it's plugged in it lights up red.

Brother can i buy a battery pack from you? 36volts Im from the phillippines

whats the small circuit board next to the speaker? mine is burnt for some reason and doesnt look like the one on yours.

what are the other two wires for?

I have a 37vdc battery and it shows 01.8 when testing the battery with a multimeter. Problem is I can’t find a 37vdc battery for sale anywhere only 36 volt battery. Will a 36 volt battery be ok?

Bravo

My brand new hoverboard run time is around 25 minutes then it cut off power of board. At full charge it was around 41.5 V and after 25 minutes the battery voltage was only 37.8 V for cut off. Why is the voltage still so high and already there was a cut off the power? At wat voltage should the board switch off? Any suggestions?

Do we have to buy a charger to find out?

Hi. The charger battery briefly blinks red but then stays green. When I measure the voltage I get 32v though - not nearly as low as your battery here. Is that considered bad? The hoverboard doesn’t turn at all btw.

where da ya get the battery from

Where do you buy batteries

I tested my battery and it reads 40.5V but is a 36v battery is this a bad battery

Thanks!

like it!

Hi, what voltage is it when it is empty? Mine reads 39.68 voltage when it is full even though it's a 36 volt battery. Also is it bad to run it to empty?

i have a problem with my hoverboard, it will randomly shut off while riding or when there is a large load (when you lean forwards too fast) but now its mostly just doing it on its own even when i go slow, i checked the battery and its at 41v even though its supposed to be 36v? i measured it from the end of the plug not the batteries them self so i dont really know whats going on here. im worried it might be a logic board problem but i overviewed the board and the components seem fine (no burn marks or anything) HOWEVER i did get this board refurbished and i actually got a refund for it so i basically got it for free so im not afraid to experiment with it but i would love to get it working again. batteries are around $40-50 new for a samsung brand battery so if i know for sure thats the problem i will go with name brand but i need someones help because im clueless, i tried testing the battery whilst it was plugged in to the board and im not sure if its my volti-meter or what but its not getting anything whatsoever, i tried switching to amps and testing it and somehow my meter shorted the connections through its self (fairly certain i didnt touch two pads by accident). edit: still powers on and functions. I was quick to remove the prong before it welded to the board or something.

Mine indicates BLUE on the board as if it's charging but it's been charging forever and it doesn't turn on !! Help

where did you buy the batterie ?

3.8V is a FLAT battery - perhaps used to 'simulate' a dead battery - even a duff battery, off load, would produce over 20V

It says 35 volts on a 36 volt battery is the battery bad? Please react back

Hi when I test my battery it shows 32.2v but when connected to the charger it shows 41.8v dose this mean my battery in knackerd cheers It has been on charge for hours but stays at 32.2v Thanks

Battery tested 25.2v battery testing at 24.4v hoverboard atill wont charge

This is so fucking confusing. You say if the light is green and if when you plug it into the hoverboard if it stays green then is an indicator that is bad? WTF?

what he doesnt tell you in this video that You can repair the battery! but he rather have you send it to him so he can enjoy all them cells

Just bought a BRAND NEW ONE and it doesn't work at all. Do they have a customer service number where you can speak to humans??

Selling these batteries for a $100 when you can buy a brand new hoverboard for around that price. Nice try streetsaw

HOLY $ _ _ _ ! YOU should DELETE... This ? Video ? This is NON-SENSE !